Starter Kill Confusion

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46168
Printed Date: May 13, 2025 at 7:03 PM

Topic: Starter Kill Confusion

Posted By: realsynthetics
Subject: Starter Kill Confusion
Date Posted: December 27, 2004 at 11:27 PM

I'm a little confused as to where these wires should be routed...

https://dodgeintrepid.net/photopost/data/500/2890starter_kill_layout.jpg posted_image

I'll cover what I'm not confused with first:

-The orange wire will tap into the "ground when armed wire" and pin 86

-The violet wire from the starte rinput will be on the vehicle side of the relay setup then through on to pin 87a of the relay

-The wire on pin 30 connects to the relay side of the cut starter wire...(module side)

MY ONLY CONFUSION

There is a wire on pin 85 that is assigned to the ignition switch. Now, does this mean I need to tap this wire into ignition 1 or into ignition 2....or into something else. Any help would be appreciated. Thank you.

Replies:

Posted By: realsynthetics
Date Posted: December 28, 2004 at 12:26 AM

No ideas?

Posted By: gcorrea
Date Posted: December 28, 2004 at 12:41 AM

pin 85 should "see" 12volts when the key is at on and run position only.

-------------
gcorrea

Posted By: profuse007
Date Posted: December 28, 2004 at 12:58 AM

it doesnt matter which ignition wire, both will give 12volts when turning key in cyl. thus makin the starter kill relay active.

realsynthetics wrote:

No ideas?

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: realsynthetics
Date Posted: December 28, 2004 at 5:32 AM

Damn you guys are good! Thanks for your prompt and accurate help.

-Duncan