I have a 86 camaro, hooking up an alarm system with remote start should be fairly easy right? wrong!
ok first, it says hook up to ignition 1, ignition 1 again, then the ACC is this 3 diffrent inputs or do i hook 2 wires to the ignition and the 3rd to acc?
Next, i cant find my ignition harness. If anyone knows it's location on an 1986 camaro or can get me a copy of a wiring diagram it would be greatly appreciated.
thanks guys!
-------------
On Dubs
| 12V|red |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|pink |+ |ignition harness |
| ACCESSORY|orange |+ |ignition harness |
| POWER LOCK|lt. blue |+ |drivers kick panel |
| POWER UNLOCK|black |+ |drivers kick panel |
| PARKING LIGHTS +|brown | |switch or rear harness |
| HEADLIGHTS|yellow |+ |at switch |
| DOOR TRIGGER|white |- |pin or courtesy light |
| TRUNK/HATCH PIN|BLACK/ orange |- |at cargo light *1 |
|TRNK/HTCH RELEASE|brown |- |at switch *2 |
| TACHOMETER|white, PURPLE / white | |at coil |
| BRAKE WIRE|lt. blue or yellow |+ |at brake pedal switch |
| HORN TRIGGER|black |- |steering column |
| WIPERS|purple |+ |L of steering column |
| LF WINDOW UP/DN|dk. blue - brown |C |at window switch |
| RF WINDOW UP/DN|blu/wht - tan |C |at window switch |
Notes:
*1 If no cargo light must add pin or magnetic switch. *2 Right side of console behind gear selector. If you send 12V+ to this wire the engine will crank.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
" *2 Right side of console behind gear selector. If you send 12V+ to this wire the engine will crank." (YOUR QUOTE)
so the ignition harness is located on the right side of oc console behind the gear selector?
I should have included this info the first time:
its an FM-2009 remote start & paging system. This is what the wiring instructions read:
6 pin Hi-current conectors:
Red: +12v input
Red: +12v input
Brown: ignition 1 (secondary ignition 1 output) *1
Yellow: Ignition1 (primary ing output and alarm input for ign "on")*2
Orange: Accessory
Purple: Starter Output
Notes: *1 where is it's location *2 is this the same thing?
-------------
On Dubs
Your ignition wires are located in the steering wheel column going down into the driver's dash area. You will have to remove the lower portion of the driver's dash and follow the wires going down along side the steering column from the key cylinder. All of the above wires from the wiring diagram will be located here for the engine starter. The *2 note is for the TRUNK RELEASE only and is only a warning to installer's that it is a (-) trigger not a (+) one and if a (+) is used it will crank the engine, but not start it.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA