Tach Reading or Voltage Reading
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46243
Printed Date: May 14, 2025 at 2:08 AM
Topic: Tach Reading or Voltage Reading
Posted By: realsynthetics
Subject: Tach Reading or Voltage Reading
Date Posted: December 28, 2004 at 6:54 PM
I've begun the install of my remote starter, and want to know if I should use Tach check or Voltage Check. Also, could someone please explain to me what each of these mean?
Replies:
Posted By: profuse007
Date Posted: December 28, 2004 at 7:22 PM
-use tach whenever possible.
(reference to DEI units.)
-if engine checkin ON, the RS will monitor the tach(engine RPM) or voltage (whichever mode you use).
----if it see tach's RPM is too high, it shuts off. TACH mode doesnt concern w/ crank time.
----if it see voltage is dropping drastically (like if youre to jump start another car or turn up ur stereo sys), then it will shut off. VOLTAGE does concern w/ crank time.
_______________________________
if youre to turn off ENGINE check mode, then it will not monitor tach nor voltage.
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: realsynthetics
Date Posted: December 29, 2004 at 1:05 AM
Awesome...you really helped me out there :) Thank you
|