Need Help on Remote Start for 93 Nissan Maxima

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=4631
Printed Date: June 10, 2024 at 3:32 PM

Topic: Need Help on Remote Start for 93 Nissan Maxima

Posted By: gman4ever
Subject: Need Help on Remote Start for 93 Nissan Maxima
Date Posted: October 19, 2002 at 4:56 PM

I am trying to install a CrimeStopper RS900IV remote start/keyless entry system on a 1993 Nissan Maxima GXE with keyless entry (bottons on door handles). I have the locks and trunk all done, but when I start with remote, the starter just keeps on running, while the engine is already started.

My Unit has a Tachless Mode. However, when I programed it, nothing changed. So I ran a tach wire from coil, and still, no avail. The unit even confirmed that it recieved a valid tach input signal by flasing the lights twice in TachFind mode. The starter just keeps on spinning. I have installed a Bulldog starter and keyless entry before, with no problems. But this is something different. Could it be a defective unit? Any help or info would be appreciated.

Replies:

Posted By: Chris Luongo
Date Posted: October 19, 2002 at 9:23 PM

I'll take a guess that you might have hooked up the starter wire as an ignition or accessory by mistake..... it couldn't hurt to go and check those connections again.

Posted By: Velocity Motors
Date Posted: October 19, 2002 at 9:42 PM

Were there any pin switches to turn OFF /ON the tachless and tach required mode ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: SOUND PRESSURE
Date Posted: October 19, 2002 at 9:44 PM

Do you have an option like "anti-grind mode?" If you do make sure that it is on.

-------------
Sound Pressure

You know you have the right amount of pressure when your eyes start to water! Now you've got Juice!

Posted By: gman4ever
Date Posted: October 24, 2002 at 7:43 PM

Thanks for all your help. I found out that the wire harness on my unit was not pluged in the right way. I assumed that if it fits, then it is the right way, like many harnesses that have the special thread so you cant plug it in wrong. Well anyways, the ACC was going to the starter and the Starter was going to the accesories. I fliped over the harness plug and it works great.

Posted By: djfearny2
Date Posted: October 24, 2002 at 8:18 PM

yea you got to make sure that dont happen you could have messed up starter.,

-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.