1998 DODGE DURANGO REMOTE START

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46317
Printed Date: May 15, 2025 at 6:57 PM

Topic: 1998 DODGE DURANGO REMOTE START

Posted By: superbee1969pa
Subject: 1998 DODGE DURANGO REMOTE START
Date Posted: December 29, 2004 at 6:52 PM

INSTALLING A CODE ALARM REMOTE STARTER ON A 1998 DODGE DURANGO WITH FACTORY ALARM. THE REMOTE STARTER SAYS IT HAS A +OUTPUT FOR THE ALARM AND THE WIRING CHARTS I HAVE SAYS THE TRIGGER WIRE IS -INPUT. ANYTHING SPECIAL I HAVE TO DO?

Replies:

Posted By: swamprat323
Date Posted: December 29, 2004 at 7:14 PM

What model of alarm. And what trigger are you trying to hook up to.

Posted By: cheluboi
Date Posted: December 29, 2004 at 10:07 PM

what exactly are you trying to do? Are you trying to send a pulse to disarm the factory security? Not sure what you want to do but if you have a + output wire and the wire you want to trigger is a - pulse trigger then you have to ad a relay......can't tell you how to hook it up until i fully understand what it is you want to do.

-------------
islandboy.....yay-E-yay!

Posted By: Captanham
Date Posted: December 30, 2004 at 6:11 PM

yea you are going to need a relay, hook your + output to pin 85 of a relay, hook ground up to 87 and 86, and then use 30 as your ouput for the trigger on the vehicle, ,, that's for if you are trying to disarm the factory alarm, which is what i think you are talking about... if not then msg me back, fill me in a little more

-------------
Bad Boys Customs
audio - video - security

If you use it. Suport it. Donate to the 12 volt!

Print Page | Close Window