Print Page | Close Window

difficult tech question ’01 dakota

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46428
Printed Date: May 17, 2024 at 9:01 PM


Topic: difficult tech question ’01 dakota

Posted By: billiards4me
Subject: difficult tech question ’01 dakota
Date Posted: December 30, 2004 at 8:41 PM

i'm planning on installing a clifford matrix rsx 3.5 into a 2001 dodge dakota r/t 5.9L.  using this forum i found the wire schedule at https://directechs.com/directwire/wire_body.asp?action=select&yr=3233&product=Security  but what my question is, has to do with the door locks.  if you notice, it has a note saying:

Power Lock WHITE/ green  -  conn. 2, pin 10 @ CTM
Notes: Lock is negative trigger thru a 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays.

so how am i to hook up a standard after market alarm to one wire with resistors???

and also, any comments on the matrix rsx 3.5?  good places to buy? 

thanks for all the help!




Replies:

Posted By: auex
Date Posted: December 30, 2004 at 8:46 PM
It is simple enough. If your alarm has built in relays then you wire it to pass a negative trigger and on the lock output you put a 820ohm resistor inline and on the unlock you place a 330ohm resistor inline. If your alarm does not have built in relays then you will need to wire relays (1 for lock and 1 for unlock), pin 85 lock or unlock output from alarm, 86 +12V, 30 ground, 87 output to door locks.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.


Print Page | Close Window