Print Page | Close Window

Doorlocks on 97 GMC suburban

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46485
Printed Date: October 31, 2024 at 5:45 PM


Topic: Doorlocks on 97 GMC suburban

Posted By: Glackowitz
Subject: Doorlocks on 97 GMC suburban
Date Posted: December 31, 2004 at 12:25 PM

HEllo all its been awhile since I have done car security as I do Custom home audio now. I am adding a remote start with keyless entry to my sister inlaws GMC suburban and not sure on the doorlock wiring.

I have found in some sites to use + pulse to lock and unlock but remember reversing polarity on some gm's as well as - pulse.

Not sure where to go on this one

Thanks for any help

Glack




Replies:

Posted By: hayman
Date Posted: December 31, 2004 at 1:28 PM

Go here to designtech website https://www.designtech-intl.com/Content/techsupport/wirecolors/VehicleDetail?modelID=608

That should take you to your truck  check the notes at the bottom of the page.  Then go to the document section and find the note # to check out the diagram.





Posted By: KarTuneMan
Date Posted: December 31, 2004 at 5:31 PM
12volts red   +  ignition harness
Starter yellow or purple   +  ignition harness
Second Starter     
Ignition pink   +  ignition harness
Second Ignition white   +  ignition harness
Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.
Third Ignition pink/white   +  ignition harness
Notes: The pink/white does not exist on all models.
Accessory orange   +  ignition harness
Second Accessory     
Keysense     
Power Lock lt. blue   +  either door boot
Power Unlock white   +  either door boot
Lock Motor gray    drivers door boot
Unlock Motor tan    drivers door boot
Parking Lights+ brown    headlight switch
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger purple   -  headlight switch
Dome Supervision white   -  headlight switch
Trunk/Hatch Pin tied in with doors    
Hood Pin     
Trunk/Hatch Release black or blk/wht    low in the drivers kick
Notes: Positive trigger on models with rear lift window, and 5 wire on models with cargo doors.
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Disarm No Unlock     
Tachometer white   AC ECM
Notes: Diesel wait to start wire is dk. blue (-) located at the instrument cluster.

ECM is located on drivers side inner fender. Tach wire found in a black plug marked *white*.
Wait to start     
Brake Wire white   +  at brake pedal switch
Parking Brake     
Horn Trigger black   -  at column


-------------




Posted By: Glackowitz
Date Posted: December 31, 2004 at 7:16 PM

Thanks for the help guys, I got it all up and running this afternoon. the light flash out from the starter was a negative, so I used a relay to convert to posituve and now it doesnt work. It did have a negative out when active so I used that to power the parking lights

Glack






Print Page | Close Window