Ign 3 control
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46498
Printed Date: July 15, 2025 at 8:04 AM
Topic: Ign 3 control
Posted By: Wrenchturner2
Subject: Ign 3 control
Date Posted: December 31, 2004 at 3:07 PM
I have installed a few remote starters, never installed a bypass ( in this case passlock 2) but I am now forced to learn. I have ign 1,2,3 (ign 3 being for hvac) and acc to control and I have to send a signal to this bypass. This is an RS900VII crime stopper. It seems if it were not for the bypass signal I would have enough contolled outputs. Can I just tee off of ign 1 for the bypass enable signal?
Replies:
Posted By: mykicks007
Date Posted: December 31, 2004 at 3:55 PM
You could split off the ign2 wire from the alarm unit and diode isolate going to ign 2 in car and bypass
Posted By: profuse007
Date Posted: December 31, 2004 at 4:25 PM
-ignition 3 from the alarm unit, it has a current of 200mA(or more) (-). its fine that youre using for the passlock 2.
-if you have another wire that shows (-) when RS, you can use that wire to power up ur car's ignition 3 (ur HVAC). the wire of the alarm youre looking for is something like, "status".
vice versa, you can use the status (-) 200mA for the bypass and use the ign3 for ur Igniton 3 (ur car).
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
|