Boa 265B Remote Start & Keyless Entry

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46660
Printed Date: April 28, 2024 at 9:46 PM

Topic: Boa 265B Remote Start & Keyless Entry

Posted By: chipvie
Subject: Boa 265B Remote Start & Keyless Entry
Date Posted: January 02, 2005 at 1:09 PM

Last night I successfully install a BOA 265B remote start end keyless entry system on my 1993 Plymouth Grand Voyager... and everything works fine... but there is odd bug in the system.

After I remote stert the vehicle, about 10 seconds pass and then the parking lights AND the DASH lights flash !

If I turn on the parking lights, they stop flashing and so do the dash lights.

Other than this.. everything works great :) Any help would be much appreciated !

Replies:

Posted By: BNLUIS
Date Posted: January 02, 2005 at 2:58 PM

That unit supposed to flash the parking light unless it is programmed to no steady.

-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.

Posted By: chipvie
Date Posted: January 02, 2005 at 4:34 PM

BNLUIS wrote:

That unit supposed to flash the parking light unless it is programmed to no steady.

Thanks for your prompt reply.

I probably didn't describe what is happening very well. After I remote start the vehicle, the flashers and the dash lights will begin to flash- about 10 seconds after the vehicle has started. They continue to flash indefinitely. Even if I get in the vehicle and insert the key and drive away. The only way to get them to stop flashing is to shut down the vehicle and start it with the key, or turn on the parking lights.

Besides this... everything works pefectly- the lights flash properly when I remote start it, or use the keyless entry system.

Thanks again for your help :)

Posted By: mbenzw203
Date Posted: February 07, 2005 at 2:31 AM

chipvie wrote:

BNLUIS wrote:

That unit supposed to flash the parking light unless it is programmed to no steady.

Thanks for your prompt reply.
I probably didn't describe what is happening very well. After I remote start the vehicle, the flashers and the dash lights will begin to flash- about 10 seconds after the vehicle has started. They continue to flash indefinitely. Even if I get in the vehicle and insert the key and drive away. The only way to get them to stop flashing is to shut down the vehicle and start it with the key, or turn on the parking lights.
Besides this... everything works pefectly- the lights flash properly when I remote start it, or use the keyless entry system.
Thanks again for your help :)

sounds the remote starter is still active. did you hook up the brake kill switch? when you press the brake, the remote starter turns off.

Posted By: Kenny214
Date Posted: February 20, 2005 at 12:49 PM

Hey, when you guys install the module, there are 6 thick wires not in a harness format, what color goes into which terminal? I can't find it anywhere! There's two red ones, an orange one, two pink ones(one with a white stripe), and a purple one. Let me know!

Ken

Posted By: bigdaddy96
Date Posted: February 22, 2005 at 4:20 PM

The brown wire on the BOA is not connected to the proper wire at the brake pedal. If that wire does not see 12 volts when the brake is pressed, the RS will not shut down. As for the heavy guage wires, refer to page 56 for the wiring guide.

Posted By: bigdaddy96
Date Posted: February 22, 2005 at 4:21 PM