White/Blue Remote Start activation input

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46679
Printed Date: September 01, 2025 at 6:36 AM

Topic: White/Blue Remote Start activation input

Posted By: BRIANSHAW
Subject: White/Blue Remote Start activation input
Date Posted: January 02, 2005 at 3:43 PM

02 Jeep liberty viper 791vx

I have no clue where this wire should go and the instrutions only say that

"This input comes from the factory set to 2 activation pulses. This means that is is nessissary to have 2 consecutive ground pulses on the white blue wire for the remote start to activate or deactivate. The same holds true for the remote control activation when set to a two pulse setting it is nessissary to press the * button twice for the remote start to activate oe deavtivate.

Replies:

Posted By: swamprat323
Date Posted: January 02, 2005 at 4:52 PM

You dotn need to have that wire hook up, waht you can do it wire a button switch to it, and if you push it 2 times or waht ever it set at the car will start. It can be used say you go to a store and want to kept the car runnign push the button 2 tiem sand the RS will be on sao u can take your keys with ya, you can still do that just use the remote as the car is running.

Print Page | Close Window