im putting in a remote starter looking for wiring diagran and how to bypass factory pass key sh*t can anyone help dash i apart and waiting lol 2001 dodge grand caravan with pass key thanks in advance
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | YELLOW (NOTES BELOW | IGNITION SWITCH HARNESS** |
Ignition #1: | | PINK/WHITE | IGNITION SWITCH HARNESS* |
Ignition #2: | | N/A | |
Ignition #3: | | N/A | |
Accessory: | | N/A | |
Brake Light: | | WHITE/ TAN | IGNITION SWITCH HARNESS* |
Tach Signal: | | PURPLE / ORANGE (AC) | GRAY CONNECTOR BY IGNITION MODULE |
Parking Lights: | | WHITE/ BROWN (-) | AT HEADLIGHT SWITCH*** |
Headlights: | | N/A | |
Diesel Glow Plug: | | N/A | |
Clutch Bypass Wire: | | N/A | |
Notes: | | * Many Of These Vehicles Are Equipped With A Transponder (Even If The Key Is Black). Use Universal Alarm Bypass Module Part Numner 2x402 Where X Can Be Any Number. ** NOTE!!! A Second Start Wire (PURPLE / Brown) Needs a relay installed to provide a ground (-) through a 180 Ohm Resistor during crank in order to remote start the vehicle, See Installation Note #162. ***The parking lights are negative trigger through a 2.1K ohm resistor. ****All DesignTech remote starters except the 2xx22 have an ignition 3 output - it is the WHITE/ black in the 'control harness'. This wire will be used to control the bypass module, if needed. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | RED | IGNITION SWITCH HARNESS (MAX #AMPS) |
OEM Alarm Disarm: | | VIOLET/LT. BLUE | AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE****** |
Dome Lights/Superv: | | BLACK/ WHITE (-) | AT 4 PIN PLUG NEAR FUSE PANEL |
OEM Horn: | | GREEN/ PURPLE (-) | STEERING COLUMN HARNESS |
Power Lock: | | PURPLE / GREEN | AT PLUG AT PCM ON FIREWALL ***** |
Power Unlock: | | Single wire system | AT PLUG AT PCM ON FIREWALL ***** |
Trunk Release: | | VIOLET/TAN | AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE ****** |
Alarm Input Wire: | | BLACK/ WHITE (-) | AT 4 PIN PLUG NEAR FUSE PANEL |
Notes: | | *****for the 2001-02 Caravan Lock is negative trigger through a 5.3k ohm resistor. Unlock is negative trigger through a 2.0k ohm resistor. For the 2003 Caravan Lock is negative trigger through a 2.2k ohm resistor. Unlock is negative trigger through a 390 ohm resistor. The Body Control Module (BCM) is in the driver kick panel near the the parking brake, ******See Installation Note #211. A Single Pulse Of Ground Through A 2.2 K-Ohm Resistor Will Open The Liftgate. POWER SLIDING DOORS: Violet/Dk. Blue Wire At Switch. Driver's Side - A Single Pulse Of Ground Through A 2.7 K-Ohm Resistor. Passenger's Side - A Single Pulse Of Ground Through A 1.5 K-Ohm Resistor. ****** To disarm the OEM alarm a negative trigger through a 9.20k ohm resistor. |
https://www.designtech-intl.com/Content/techsupport/documents/section04/note144.pdf This is a link to making your own bypass module, but I would recommend buying one if you have never made one before.
Craig...