03 Monte Carlo wiring colors same as 02?
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46750
Printed Date: June 30, 2025 at 6:37 AM
Topic: 03 Monte Carlo wiring colors same as 02?
Posted By: Helf
Subject: 03 Monte Carlo wiring colors same as 02?
Date Posted: January 03, 2005 at 8:49 AM
Replies:
Posted By: KarTuneMan
Date Posted: January 03, 2005 at 9:00 AM
| 12volts | red | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. | |||
| Starter | yellow | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. | |||
| Second Starter | N/A | ||
| Ignition | pink | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. | |||
| Second Ignition | green | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. | |||
| Third Ignition | |||
| Accessory | orange | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. | |||
| Second Accessory | brown | + | ignition harness |
| Notes: The ignition harness is located far right of the steering column, behind the ignition switch. This wire must be powered as an accessory wire. If powered as an 2nd ignition the car will not crank. | |||
| Keysense | |||
| Power Lock | ORANGE / black | - | gray 24 pin plug @ BCM |
| Notes: Lock requires a negative trigger thru a 470 ohm resistor. Unlock requires a straight negative trigger. MUST use relays. The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Can also use Directed 456A interface module. | |||
| Power Unlock | same wire as power lock | ||
| Lock Motor | |||
| Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts. | |||
| Unlock Motor | |||
| Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts. | |||
| Parking Lights+ | do not use | ||
| Parking Lights- | white | - | pink 24 pin plug @ BCM |
| Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Must isolate this wire from the BCM to avoid the service engine soon light. See DirectFax document 1600 for wiring information. | |||
| Hazards | |||
| Turn Signal(L) | |||
| Turn Signal(R) | |||
| Reverse Light | |||
| Door Trigger | blue & blue/white | - | gray 16 pin plug @ BCM |
| Notes: The driver door trigger wire is blue. Blue/white will catch the passenger door. Use both wires and diode isolate each. The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information. | |||
| Dome Supervision | use door trigger | ||
| Trunk/Hatch Pin | RED / black | - | gray 24 pin plug @ BCM |
| Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information. | |||
| Hood Pin | |||
| Trunk/Hatch Release | black | - | release switch |
| Power Sliding Door | N/A | ||
| Factory Alarm Arm | |||
| Factory Alarm Disarm | lt. green | - | gray 16 pin plug @ BCM |
| Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. | |||
| Disarm No Unlock | see factory alarm disarm | ||
| Tachometer | white | ac | ignition coil |
| Wait to start | N/A | ||
| Brake Wire | white | + | brake pedal switch |
| Parking Brake | |||
| Horn Trigger | black | - | steering column |
| Notes: Horn can also be found at a black plug with a blue insert above the gas pedal. | |||
| Memory Seat 1 | |||
| Memory Seat 2 | |||
| Memory Seat 3 | |||
| Immobilizer Bypass Module: | Required: Yes | Type: Passlock 2 | Part #: 555L or 555T |
-------------