Print Page | Close Window
Starter



-------------
DaBouch



Posted By: drhardware1
Date Posted: January 03, 2005 at 11:27 PM
do u have an actaul diagram ?




Posted By: boucher911
Date Posted: January 03, 2005 at 11:29 PM
you want pictures  of where all the wires are cause on an 89 caprice it should be pretty straight forward where is says is where it is

-------------
DaBouch




Posted By: drhardware1
Date Posted: January 03, 2005 at 11:29 PM
so this works with the Autopage RS-855 LCD right!




Posted By: drhardware1
Date Posted: January 03, 2005 at 11:31 PM
well i'm new with all this just want to be sure but the pics would be nice to go over.




Posted By: boucher911
Date Posted: January 03, 2005 at 11:31 PM
do you what the wiring for the remote module or do u want the wiring for you car?

-------------
DaBouch




Posted By: drhardware1
Date Posted: January 03, 2005 at 11:32 PM
wirng for the remote module




Posted By: boucher911
Date Posted: January 03, 2005 at 11:34 PM
ohh ok thats is the correct wiring for the car, but the module you will have to either find somone with the wiring in for for that make of try to find that companys webpage check for a webpage, the remote start didi not come with the diagram?

-------------
DaBouch




remote start help

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46790
Printed Date: May 29, 2024 at 5:54 AM


Topic: remote start help

Posted By: shredder130
Subject: remote start help
Date Posted: January 03, 2005 at 5:35 PM

ok here is the pin out of my alarm

Pin 1 RED WIRE A :Main Power Input A (+).Connect to the battery or constant power wire at the ignition
switch with a minimum 30 Amp supply.Remove the fuse until the installation is complete and all wiring
is checked.

Pin 2 RED WIRE B :Main Power Input B (+).Connect to the battery or constant power wire at the ignition
switch with a minimum 30 Amp supply.Note:if connecting at the ignition switch it is highly
recommended to use separate power wires for each Red wire,each with a minimum 30A supply.
Remove the fuse until the installation is completed and all wiring is checked.

Pin 3 BROWN WIRE :Second Ignition Output (+).The Brown wire provides +12V for a second ignition
wire.This wire may instead be programmed for use as a second accessory or second starter wire.

Pin 4 ORANGE WIRE :Accessory Output (+).Connect to the accessory wire coming from the ignition
switch that supplies power to the heater/air-conditioner.Some cars may have multiple accessory wires.

Pin 5 YELLOW WIRE :Ignition Output (+).Connect to the main ignition wire that provides +12V when the
ignition is on and while cranking the starter.

Pin 6 VIOLET WIRE :Starter Output (+).Connect to the the vehicle ’s starter wire.




ok i need to know how to install it in a 1985 coupe deville fwd

here's the info

Constant 12V+     Red        Ignition Switch Harness
Starter      Yellow      Ignition Switch Harness
Ignition      Pink      Ignition Switch Harness
Accessory      Orange      Ignition Switch Harness
Tach      White      Distributor
Neutral Safety Wire      ORANGE / Black      Engine Control Module
Brake Switch      White      Brake Switch
Parking Lights      Brown      Light Switch
Head Lamp      Yellow      Light Switch
Door Trigger      White (-)      Driver's Kick Panel
Door Lock      Light Blue      Driver's Kick Panel
Door Unlock      Black      Positive Trigger
Horn Wire      Black (-)      Steering Column



Replies:

Posted By: shredder130
Date Posted: January 03, 2005 at 5:36 PM
it doesn't seem hard, its just i haven't done one before and i am afraid of burning up my baby




Posted By: boucher911
Date Posted: January 03, 2005 at 7:24 PM
do it like it says it straight foward anymore questions ask


-------------
DaBouch




Posted By: JWorm
Date Posted: January 03, 2005 at 8:22 PM
What was the question?




Posted By: drhardware1
Date Posted: January 03, 2005 at 11:10 PM
i need a wiring diagram for a 89 chevy Caprice cos i'm trying to hook up a Autopage RS-855LCD can u help me?




Posted By: boucher911
Date Posted: January 03, 2005 at 11:12 PM
do you have a serial # ?

-------------
DaBouch




Posted By: drhardware1
Date Posted: January 03, 2005 at 11:18 PM
wHAT SERIAL #




Posted By: boucher911
Date Posted: January 03, 2005 at 11:19 PM
sorry i wrote in a wrong post, 89 chevy hold on

-------------
DaBouch




Posted By: boucher911
Date Posted: January 03, 2005 at 11:25 PM

 

Constant 12V+Red  Ignition Switch Harness  Yellow  Ignition Switch Harness 
Ignition Pink  Ignition Switch Harness 
Accessory Orange  Ignition Switch Harness 
Tach White  Coil 
Neutral Safety Wire ORANGE / Black  Gear Select Switch 
Brake Switch White  Brake Switch 
Trunk Release Black  Switch 
Trunk Pin Dark Green  (Wagons only) (-)Driver's Kick Panel 
Parking Lights Brown  Light Switch 
Head Lamp Yellow (+)  Light Switch 
Hood Pin n/a   
Factory Disarm n/a   
Door Trigger White (-)  Driver's Pin Switch 
Door Lock Light Blue  Driver's Kick Panel 
Door Unlock Black  Positive Trigger 
Horn Wire Black (-)  Steering Column 
Windows Up LF=Blue, RF=Blue/White 


Print Page | Close Window