hey evryone, whats going on.....
I was hoping that evryone could give me some assistance. I purchased the Alpine 150r alarm system about a year ago and finaly decided to start instaling it. I got about 20% of the way through and realized i didnt understand very much of the procedure, i was hoping that you could help with the wiring. The ignition wiring is confusing the crap out of me and i also have a factory instaled alarm ill need to buypass. I want to use both of these systems together if at all possible. My vehichle is a 96 Chrysler Concorde LXI with all the options. I want the factory alarm still intact due to the fact it monitors the trunk key cylinder as well as the ignition one. please help! thanks in advance!
~Brandon
ok....i figure since im not getting much help ill be a little more specific with my question. the wiring is as follows....
~Red requires a constant 12v source, so ill use the pink/ blac in the ignition harness
~yellow is for a true ignition source when motor is cranking......is this ignition wire 1,2,3, or is it the starter wire?
~black is ground....im figuring somewhere in the center console
~green is for a negative door switch, so il use yellow(-) door trigger
~blue is for hood/ trunk pin, but i only have a trunk pin (BROWN / black) do i need a hood pin....i would like one....how can i make?
~white is for parking light flash, so il use the blac / YELLOW
~brown is for siren so that obviously goes to the siren....
~orange is a (-) armed output 200mA....how can i use that to make my LED and neons flash like the parking lights?
~ORANGE / black is the starter interupt output (-) 200mA.....this is the one i have no clue where to hook up.
.....for the most part i understand the rest except for how to link up my keyless entry to the alpine remote? i dont want to use both the factory remote AND the new one.
thanks in advance again evrybody!