How to reset an alarm?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47018
Printed Date: May 10, 2024 at 9:16 AM

Topic: How to reset an alarm?

Posted By: percyv143
Subject: How to reset an alarm?
Date Posted: January 05, 2005 at 9:50 PM

hi. i'm having a trouble to put my alarm to the code-learning mode after following the steps. i had already checked the wiring and all alarm features are working fine. the steps are to turn the ignition from ON to OFF 4x and put back to ON and supposedly the alarm will chirp but doesn't. my alarm is an Option Group LD 163-6C. link to diagram : https://percyv143.home.comcast.net/pix/alarm1.jpg

i tried disconnecting the supplu harness but still can't.
help...

thanks.
percy

Replies:

Posted By: daze
Date Posted: January 10, 2005 at 5:12 AM

and your sure that the yellow wire is hooked up to an ignition or accessory wire !?

Posted By: percyv143
Date Posted: January 10, 2005 at 6:41 AM

the yellow wire is connected to the ACC terminal at the back of the key cylinder.

Posted By: riceman
Date Posted: January 10, 2005 at 2:32 PM

Hey, I've don't have any experience with this alarm but does this alarm require a door to be open (ie dei ) or does it require a hood open (ie crimestoper) during programming. I know some of these newer cars dont have enough current comin from the pinswitches to actually show a door opening but has enough current to set off the alarm . I did an infinity g35 once that had that problem what i did was cut the negative door trigger wire n put direct to ground to get into programming mode. Well hopefully that help n good luck.