Commando RS-HTBK2 & Acura TL

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47220
Printed Date: May 10, 2025 at 3:25 PM

Topic: Commando RS-HTBK2 & Acura TL

Posted By: carlmorrell
Subject: Commando RS-HTBK2 & Acura TL
Date Posted: January 08, 2005 at 4:34 PM

Arrgh, what an idiot I am for attempting this myself. I just installed in a Commando EZ-2500 remote starter in a 1999 Acura TL.

It works fine as long as there is a key in the ignition. (The same key in the transponder.) I am sure I wired the bypass properly. I can hear the bypass relay click. I think the problem is I can not get the loop in the right position on the igniton lock. Any hints?

Thanks in advance, Carl

Replies:

Posted By: Craig3708
Date Posted: January 08, 2005 at 4:57 PM

If you are using the pre-fab loop-DON'T

I usually cut off the loop, strip the wire coating approx 7-8 inches and wrap it two times around the tumbler (very tight) and tape it in place. Make sure the wire is out towards the front as far as possible..

Good Luck

Craig

Print Page | Close Window