Print Page | Close Window

CS 2400 programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47257
Printed Date: July 17, 2025 at 6:51 PM


Topic: CS 2400 programming

Posted By: magnarider
Subject: CS 2400 programming
Date Posted: January 09, 2005 at 3:21 AM

I have a 1998 explorer with a Command Start CS 2400 remote starter. When I brought this truck I had to put a cut off key in the ignition to remote start it. I installed a Astro Flex OM ford keypass module or ford transponder. Now I have to reprogram the CS 2400 to put out a negative on Aux 3 or white wire to be on from the remote start until shutdown (Mode 1). Can someone explain to me how to reprogram this unit. Tks Cool posted_imagerider

-------------
Cool 8D rider



Replies:

Posted By: magnarider
Date Posted: January 14, 2005 at 11:23 PM
Hi Guys

I FIXED IT!!!!!!!!!!! I had to buy a installation manual from the dealer, but it was worth the $5.00, because I saved 100's and the remote starter works great. I had to redo all the connection because the originally installer use "T" connectors. Two of the connections failed. I soldered them all. Soldering is the best way to go. I no long need to use the sawed of key. Is that GGGGGGGGGG r e a t!!!!!!!!!!!

Tks for all the information as I learnt a lot from just reading about someone else's problems. Keep on writing in.

-------------
Cool posted_image rider





Print Page | Close Window