commando ez2600 trouble
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47326
Printed Date: May 18, 2024 at 3:33 AM
Topic: commando ez2600 trouble
Posted By: my71454
Subject: commando ez2600 trouble
Date Posted: January 09, 2005 at 9:27 PM
I am currently installing a remote start and keyless entry commando ez2600 on my wifes 2003 Kia Spectra , everything is working except the start function , I am getting door lock and unlock , trunk pulse , and 5 pulses for the start funtion but the vehicle is not starting , when i get the pulses (relay clicks) the dash lights dont come on either is this a programming problem or instalation problem? I have gone over the wiring and everything is hooked up correctly , the only wires I didnt use were the pulse to start wires , I was lead to believe that they were only used for theft deterent systems.
Replies:
Posted By: ah64mark
Date Posted: January 09, 2005 at 10:45 PM
did you hook up the BLACK/ white wire to ground? did you get the tach signal for that vehicle?
-------------
ah64mark
Posted By: jrilla
Date Posted: January 10, 2005 at 12:37 AM
I am not aware of a 2600, but I am aware of a 2500. if it is a 2500, then you need to enter programming before the unit will even attempt to remote start. Look in the programming tables where it describes the type of starting: tach monitoring, voltage monitoring or timer.
-------------
J Rilla
Owner/Installer
Posted By: my71454
Date Posted: January 12, 2005 at 9:55 PM
O. K. I tried the programming and still doesnt work double checked all my current hookups and they are Ok . so I will try this Here is a list of the wires I DO NOT have hooked up maybe somebody can help . white and red for onepulse to start white and orange three pulse to start black and yello for hand brake black and gray for noise input from engine ( I have the programming set for the timer and smart sense start enable) orange ground output gray trunk black and white dome light output blue and white passenger unlock output I would appreciate any help you can give me
Posted By: plinderson
Date Posted: January 17, 2005 at 11:48 AM
I just installed a 2600. I found out after three phone calls that two things must be in place. #1 hood trigger must NOT be grounded (it doesn't need to be hooked up if you choose. And # 2 which was my problem. The hand brake wire MUST be grounded. Finally starting.... Paul
Posted By: my71454
Date Posted: January 17, 2005 at 11:11 PM
Paul you were correct it was the handbrake wire that needed to be grounded and thanks everybody for your input, this site ROCKS!!!!!!!!!!!!!
|