Need help on Disarm wire on 2000 Quest

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47382
Printed Date: July 14, 2025 at 2:15 PM

Topic: Need help on Disarm wire on 2000 Quest

Posted By: ma1311
Subject: Need help on Disarm wire on 2000 Quest
Date Posted: January 10, 2005 at 6:07 PM

Just install a remote starter on my 2000 nissan quest , I can remote start the car when the door is unlock, and when I remote start the car when the alarm is ARMED (door locked), it will trigger the alarm.

I need help on where is the factory disarm wire (and wire color) located? so I can connect FASD wire from the remote starter to it and disarm the alarm. I try locate in driver side kick panel and has no luck.

any reply and help are great appreciated.

Replies:

Posted By: profuse007
Date Posted: January 10, 2005 at 6:19 PM

A single pulse on the unlock wire will disarm the factory alarm without unlocking.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: ma1311
Date Posted: January 10, 2005 at 6:26 PM

Thanks profuse007

is this wire locate in door panel? or somewhere else, do you know the wire color by any chance? I tryed WHITE/ red, GREEN/ red and had no lock.

Is this wire a small wire or the 12g(?)

thanks again.

Posted By: profuse007
Date Posted: January 10, 2005 at 6:32 PM

its the same wire as the unlock wire. you need to diode isolate the disarm wire from the unlock wire.

| POWER UNLOCK|RED / black |- |either door harness |
Driver's Kick Panel 16 Pin Connector

heres another reference: bulldogsecurity

GREEN/ ORANGE (-) DKPanel

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: ma1311
Date Posted: January 10, 2005 at 7:16 PM

Thanks profuse007

I got info from bulldosecurity b4 I came to this forum, that's how I found out their info and my car is different, I even read thru the book by Haynes (for Mercury & Nissan) and their wiring code is not the same as mine neither.

here is my wiring coloring from my car: ( I actually did the test on all these wires)

Power unlock: GREEN/ brown

power lock: green white

key unlock: WHITE/ red

key lock: GREEN/ red

You see, all these wiring code is totally different. Can you specify by "diode isolate" means?

where else I can locate the FASD wire? I mean bay tracking from setring wheel to DKPanel

Thanks.

Posted By: profuse007
Date Posted: January 10, 2005 at 8:02 PM

does ur lock unlock work?

if it does and youre not using the RED / black for unlock. theres no need for using diodes. just plug it straight on, disarm wire from alram to the redblack.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).