MORE PATS TROUBLE
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=4739
Printed Date: July 17, 2025 at 4:04 AM
Topic: MORE PATS TROUBLE
Posted By: ucmwp
Subject: MORE PATS TROUBLE
Date Posted: October 22, 2002 at 9:19 PM
Hi. I have a 1999 mustang saleen and I installed a alarm with remote start. I also got a PKF keyless bypass. I have tried programming this bypass but the theft light continues to blink.....this is how I have been programming.....key one in the ignition on position until theft light goes out, take it out, put key two in the ignition on position, then put it in the off position, then connect the wire that goes to the bypass output on the alarm to ground and turn the key to the on posistion till the light goes out again......This is what it says to do, however when I take it out, a few seconds later the theft light comes back on and starts to blink again.....HELP PLEASE.
Replies:
Posted By: ucmwp
Date Posted: October 23, 2002 at 8:49 AM
HELP PLEASE, it started this morning like normal then it just all of a sudden died and the theft light started blinking....I tried to restart it then it was fine and never stalled again....any suggestions on programming this box?
Posted By: Ohmz
Date Posted: October 23, 2002 at 4:19 PM
whay I remember to program Paths, you need to put key one in to the ignition, turn it to the on position, then take it out and put key 2 in, turn on and then off... take tha key out and remote start the vehicle right away. If your remote start has a bit of a delay and doesn't start right away, use the wire that needs the negative input to make it start right away. This part is very important. The whole process should not take longer than ten seconds.
Posted By: Velocity Motors
Date Posted: October 25, 2002 at 10:15 AM
You only have 5 seconds maximum between each step. Are you connecting the wires within 5 seconds after the second key is pulled ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|