2002 Sebring Convertible with CodeAlarm Elite 911

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=4748
Printed Date: July 18, 2025 at 5:17 AM

Topic: 2002 Sebring Convertible with CodeAlarm Elite 911

Posted By: freakystyley990
Subject: 2002 Sebring Convertible with CodeAlarm Elite 911
Date Posted: October 23, 2002 at 10:48 AM

I have a 2002 Sebring Convertible with a CodeAlarm elite 911 series installed. It has keyless capability but it is not hooked up. When hooking it up, do I just cut right into the door lock/unlock wires (+) at the BCM or do I have to pull the door panel off and find out what kind of positive door lock system it is first?

-------------
FreakyStyley990

Replies:

Posted By: djfearny2
Date Posted: October 24, 2002 at 8:13 PM

in your car you havce a multiplex system meaning that you have on wire that controls locks and unlocks yes you can get the wire at the bcm but you will need relays one for lock and one for unlock and than you will need resistors.

-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.

Posted By: freakystyley990
Date Posted: October 24, 2002 at 9:28 PM

Thanks! I appreciate your help. I had a few other questions. When I hook the 12V fused up to the relays can I hook all them up to the ignition switch harness on one fuse? If so, how many amps should the fuse be? If not, how should I do it?

Also, for the trunk pop, do I need a relay? If so, should I hook it up at the BCM or at the trunk switch? Also, what polarity is the trunk release in this vehicle? My wiring diagram does not tell me.

-------------
FreakyStyley990

Print Page | Close Window