96 Dodge intrepid unlock/lock wires

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=47503
Printed Date: July 16, 2025 at 2:40 AM

Topic: 96 Dodge intrepid unlock/lock wires

Posted By: MinusZero
Subject: 96 Dodge intrepid unlock/lock wires
Date Posted: January 12, 2005 at 12:09 AM

Does anyone know what colors the unlock/ lock wires are?

Replies:

Posted By: KarTuneMan
Date Posted: January 12, 2005 at 2:48 AM

Its a one wire system. The wire is in the drivers kick, it's ORANGE / purple POS(+) pulse

Lock= 2.7kohms unlock=620ohms USE RELAYS

Also.....the factory alarm dis-arm wire is in the same location NEG(-) pulse, it's lt.GREEN/ orange

-------------

Posted By: MinusZero
Date Posted: January 12, 2005 at 2:56 AM

it doesnt have a factory alarm, but im installing an omega rec-11 which the outputs are a negative pulse ????/ help newbie at the wheel

Posted By: mobileworks
Date Posted: January 12, 2005 at 7:19 AM

https://www.mobileworksaudio.com/guides/intrepid93radio.htm

Does your dash look like the one in the picture above...?

If so then your door lock wires can be found in the fuse box to the left side of the dash. Remove the fuse access panel you will see three relays towards the front of the car. The two top relays are lock and unlock....you can look at the back of the fuse panel to see which one is lock and unlock...

pull the relays straight out of the fuse panel. You will see 5 pins..

*| | |

The relay socket will look like this, slide your wire from your omega into the bottom far left pin. the pins on the bottom row are small and the two top pins are large.

Relays are setup for negative trigger already.

-------------

Posted By: misterjimbo
Date Posted: January 12, 2005 at 7:44 AM

also if you do not trust mobileworks you can stick your meter in the socket after you pull out the relay and press lock and unlock buttons to make sure you are on the correct pin of the relay. it never hurts to double check. i just did one two days ago and mobile works pin location is correct.... measure twice cut once though right?

-------------

Posted By: MinusZero
Date Posted: January 12, 2005 at 9:55 AM

Cool I'll try that today

Posted By: MinusZero
Date Posted: January 12, 2005 at 3:12 PM

got working thanks guys for your help