I would like to install a Pro Start Remote Starter in a 2003 Toyota Corolla (Automatic). I had checked in the veh info database but in that only upto 2000MY is available. Any help on wiring info for this vehicle will be highly appreciated. Thanks in Advance.
Constant 12 volts | WHITE | IGNITION SWITCH HARNESS |
Ignition 12 volts | BLACK/ WHITE | IGNITION SWITCH HARNESS |
Starter | RED | IGNITION SWITCH HARNESS * |
Dome Light | RED / WHT (DR) , RED / WHT | (PS). BOTH (-) AND DIODE ISOLATE ** |
Trunk Pin Switch | RED / WHITE (-) | AT LIGHT IN TRUNK |
Parking Lamp | GREEN (+) | CONNECTOR ON BACK OF FUSE BLOCK *** |
Power Lock | BLUE/WHITE | 10 PIN CONNECTOR **** |
Power Unlock | BLUE / YELLOW | IN DRIVER KICK PANEL |
* Remove Positive Battery Terminal If Cutting To Prevent Check Engine Light. ** RED / WHITE (-) Driver Door in 11 Pin Conn, RED / WHITE (-) Passenger Door in 10 Pin Conn. Both Conn. Located On Top Front Of Driver Fuse/Junction Box ***12 Pin Connector **** Child Safety Lock - WHITE (-) In 10 Pin In Driver Kick Panel. Child Safety Door Locks
Accessories |
Window Up | D\ YELLOW P\ GRN/RED D\ RED / GRN P\ RED / BLK @ MAIN SWITCH | |
Window Down | F/ GREEN F/ BLU/WHT R/ BLU/BLK R/ BLU/RED | |
Ign Key Warn | BLUE/BLACK (-) | STEERING COLUMN HARNESS |
Trunk Release | N/A | |
OEM Horn | GREEN/ YELLOW (-) | STEERING COLUMN HARNESS |
Headlights | RED (-) | AT SWITCH OR STEERING COLUMN HARNESS |
OEM Alarm Arm | BLUE/BLACK (-) | 10 PIN CONNECTOR |
OEM Alarm Disarm | BLUE/RED (-) | IN DRIVER KICK PANEL |
Reversal Rest At Ground Power Window Circuit Diagram.
OEM Hood Pin - None OEM Keyless 12v ACC Interupt-Not Possible OEM Under Hood Horn- BLACK (+) At OEM Horn Behind Driver Grill.
Remote Start |
Tach Signal | BLACK | AT ENGINE CONTROL MODULE * |
Ignition #2 | BLACK / YELLOW | IGNITION SWITCH HARNESS (HEAT/AC) |
Ignition #3 | NONE | |
Accessory | BLUE/RED | IGNITION SWITCH HARNESS |
Neutral Safety | NOT GROUNDING TYPE - | OEM SWITCH OPENS STARTER CIRCUIT |
Brake Light | GREEN / WHITE (+) | AT SWITCH ABOVE BRAKE PEDAL ** |
Reverse Light | RED / BLACK (+) | 18 PIN CONN BEHIND PASSENGER DASH |
Rear Window Defrost | BLACK (-) | AT SWITCH |
* Engine Control Module Is Located Under Glove Box.TACH wire Is In The 35 Pin Connector, First From Left. ** Also Can Be Found In Driver Kick Panel
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
I,m looking for Diodes but unable to find any store that carries it. I'm located in Canada, Ontario Province, Brampton. I would like to connect the park lamp outputs to the indicator lamps, What Amp diode should I use? Any help in this matter will be highly appreciated.
Send me a self addressed stamped envelope and I'll send it back to you with some diodes. They are cheap and are hard to find now because Radio Shack no longer carries them or resistors. Another place to try if you don't want to wait is your local installation shop ( Future Shop or Visions )
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Go to Matheson and Dixie, on the north west coner there are about 3 electronic stores. All the store are on Matheson. They are next to each other. One of them is called AA Electronic. You will find all the diode that you need relays, fuse etc.... Private message me if you want the exacty direction of getting there. I will give you my number.
-------------
Be careful whose advice you buy, but be patient with those who supply it.

Yes, there are a few but they charge you an arm and a leg. Not the mention Mr. PST & Mrs. GST. I know you guy have it easy down there. Your money is worth a lot more to begin with.
-------------
Be careful whose advice you buy, but be patient with those who supply it.

Thanks thepencil for the address, it was a great help.
Thanks again.
Rbalan