04 excursion w/pkf-1
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48028
Printed Date: May 29, 2024 at 6:47 AM
Topic: 04 excursion w/pkf-1
Posted By: Most Wanted
Subject: 04 excursion w/pkf-1
Date Posted: January 18, 2005 at 6:06 PM
Having a hell of a time have it connected, Programs, But when i remote start led lights for a 1/4 of a second and shuts off, and the theft light starts blinking. if i remote start with key in Ign led stays lit. -------------
Replies:
Posted By: Hymer
Date Posted: January 18, 2005 at 8:09 PM
Ya need a pkf-3 I belive... Just did one the other day....
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: forbidden
Date Posted: January 18, 2005 at 8:30 PM
I show a pats3 module for the same vehicle.
-------------
Top Secret, I can tell you but then my wife will kill me.
Posted By: Most Wanted
Date Posted: January 18, 2005 at 9:11 PM
bypasskit shows me a 1. Intresting, When i called there tech they said i had the right 1 -------------
Posted By: cutter1122
Date Posted: January 18, 2005 at 10:25 PM
you need a 2 key valid to program whit pkf1
Posted By: Most Wanted
Date Posted: January 18, 2005 at 10:29 PM
intresting, define 2 key valid. on first key when light goes off do second key then do the pkf? Also when i was metering wires the ground out wire i disconnected and it shows a ground when its not connected, It makes me think its bad??? -------------
Posted By: cutter1122
Date Posted: January 18, 2005 at 10:37 PM
Posted By: Hymer
Date Posted: January 18, 2005 at 10:37 PM
Sorry about that pkf-3 the Excursion should be a pkf1 w/ 2 valid keys... thought it said Expidition....
To check your RS wireing just insert the key in the IGN and remote start it... If it goes then your wired right... if it don't then double check your wireing....
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: Most Wanted
Date Posted: January 18, 2005 at 10:43 PM
actully the pkf3 says it will work in a 04 excursion on that paper. im gonna try 1 out tomm and see. my rs wiring is fine its the bypass that isnt working. -------------
Posted By: Hymer
Date Posted: January 18, 2005 at 10:52 PM
Cool... I didn't have bypasses sheet here but that is more than likley the prob.... some of the super duty truck use them and some don't... Hope it work for ya!
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: Most Wanted
Date Posted: January 18, 2005 at 10:58 PM
i hope so to, i hate those little issues. its always something about the last car of the day. when i spoke to them today they said the only 1 that would work was the -1 now i see the 3 working. im perplexed at the issue of the led coming on for the 1/4 of a second, then shuting off, ill see tomm. -------------
Posted By: Hymer
Date Posted: January 18, 2005 at 11:16 PM
I don't remember off hand for this particular module but you need to insert both keys (do their first 2 steps) then ground the brown wire and jump the +12 with the IGN The LED should blink onece and stay solid for three seconds... (something to that effect) if your timing is OFF then you have to start over.... just read and follow all the directions...
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
|