installing right now, need help!!!!!
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=4822
Printed Date: May 31, 2024 at 2:51 AM
Topic: installing right now, need help!!!!!
Posted By: LudeBoi
Subject: installing right now, need help!!!!!
Date Posted: October 25, 2002 at 5:26 PM
I have a 98 Honda Prelude, I dont understand what the diagram say for the parking lights (RED / black + empty slot in fuse panel)??also, it doesnt say weather the door trigger is positive or negative? someone pleaseeee HELP!! thanks.
Replies:
Posted By: securinu
Date Posted: October 25, 2002 at 5:28 PM
one of the empty slots in the fuse block is the parkinglight feed just test and connect with a female connector to park light output and the door trigger is negative.
Posted By: Dunbar
Date Posted: October 25, 2002 at 9:42 PM
It would be better to connect to the RED / black wire if you can find it (less obvious.) FYI, all the triggers are negative and so are the doorlocks so you can just directly connect those two wires..
Posted By: LudeBoi
Date Posted: October 26, 2002 at 12:18 AM
THANKS to ALL you guys, I've installed everything except for the remote start (leavin it up to the pros) but i still have a problem!, the L.E.D. light will not turn off when im driving! it blinks 3 times, which means door trigger, and yes the yellow wire from the starter disable is connected, but i still left the black and green wires disconnected, can anyone help?
Posted By: Dunbar
Date Posted: October 26, 2002 at 8:44 AM
Did you connect the yellow wire on the harness to the ignition wire?
Posted By: LudeBoi
Date Posted: October 26, 2002 at 10:55 AM
There is no yellow wire coming from the harness, just a yellow one coming from the starter disable relay, thanks.
Posted By: Dunbar
Date Posted: October 26, 2002 at 7:11 PM
There should be a yellow wire on the primary remote start harness, that is the ignition input which tells the alarm when the car is started. Connect the two yellow wires to the thick yellow wire coming down from the steering column.
Posted By: LudeBoi
Date Posted: October 27, 2002 at 12:18 AM
I've got it!! thanks to ALLLL i loveee my alarmm can't wait until i get the remote start installed, i've even installed a solenoid for my trunk, n have been playing with it for a long time, haha, THANKS EVERYONE!
|