How to wire alarm?

Hello!

I have an car alarm with only one output, it provides negative signal when armed and no signal when disarmed.

I'll like to install it in civic 99, so how to wire with one output  to door lock modul and 4 blinkers modul?

For door locks should i use simple relay with two outputs, which hold negat. pulse  one for lock and  other for unlock.

What about blinkers,do they need a negativ or pozitive signal to control the blinking ?

thanks for any info:)

regards, zaho

Your alarm has NO DOOR LOCK OUTPUTS.......?

What you have described is an out put for starter disable,not door locks. Ya sure your not missin something?

Yes, i'm sure. About door lock i figure it out, i need relay which will provide negative puls on two different wires.

As for blinker i guess there is a big problem.

Still don't know --------> about blinkers,do they need a negativ or pozitive signal to control the blinking ?

bye

alarm is bulldogsecurity model 3001, it's a stupid one.

 lock and unlock, is working.just have to put in a simple relay.But it was a big problem to get a wire from alarm to modul for locking/unlockin doors..

Now i have to do some electronic tfor blinkers. It have to menage neg.output to +12V, in pulse for lock 1sec long and unlock the puls should be 2sec long.

Does the hazard switch relay need negat. puls or pozitive pulse to work.?

thanx, bye

bobk]D wrote:

---

n't use hazard lights, use parking lights

---