door pin on a 1999 Chevy Malibu

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=484
Printed Date: May 14, 2024 at 4:35 PM

Topic: door pin on a 1999 Chevy Malibu

Posted By: gpgtp00
Subject: door pin on a 1999 Chevy Malibu
Date Posted: April 27, 2002 at 2:26 PM

Whats up guys. Puttin an alarm on moms car now but the diagram i got off here only shows door pins for the 2 doors. Mom has a 4 door and also, all the triggers are individual. Am i gonna have to tie a trigger wire from each door into the 1 trigger wire for the alarm or is there one wire that i can tap into? Thanks ~Ed

Replies:

Posted By: Velocity Motors
Date Posted: April 27, 2002 at 2:33 PM

Chevrolet

Malibu

1997-2002

Remote Starter Wiring Colors and Notes
Function		Vehicle Color	Location
Start:		YELLOW	IGNITION SWITCH HARNESS *
Ignition #1:		PINK	IGNITION SWITCH HARNESS
Ignition #2:		DK. GREEN	IGNITION SWITCH HARNESS
Ignition #3:		N/A
Accessory:		ORANGE	IGNITION SWITCH HARNESS
Brake Light:		LT. BLUE	AT PLUG ABOVE BRAKE SWITCH
Tach Signal:		WHITE	AT ICM TOP REAR OF ENGINE
Parking Lights:		DK. BROWN (+)	AT HEADLIGHT SWITCH
Headlights:		DK. BLUE (-)	AT HEADLIGHT SWITCH
OEM Alarm Disarm:
OEM Alarm Arm:
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* This Vehicle Is Equipped With GM's PASSLOCK II Anti-Theft System

Chevrolet

Malibu

1997-2002

Alarm and Keyless Entry Wiring Colors and Notes
Function		Vehicle Color	Location
Constant +12 Volts:		Red	Ignition Switch Harness
Starter Kill:		YELLOW	IGNITION SWITCH HARNESS *
Ignition +12 Volts:		PINK	IGNITION SWITCH HARNESS
Dome Lights/Superv:		LT. GREEN/ BLACK (-)	OR LT. BLUE AT B.C.M **
OEM Horn:		BLACK (-)	AT STEERING COLUMN
Power Lock:		LT. BLUE	DRIVER'S KICK PANEL ***
Power Unlock:		WHITE	DRIVER'S KICK PANEL ***
Trunk Release:		BLACK (+)	AT TRUNK RELEASE SWITCH
Alarm Input Wire:		LT. GREEN/ BLACK (-)	OR LT. BLUE AT B.C.M **
Notes:	LT. GREEN/ BLACK (-) For Driver's Door Only & LT. BLUE (-) For ALL Other Doors. Diode Isolate With Cathode (Band) Facing OEM Wires. * Positive Pulse Door Lock

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: scss
Date Posted: April 30, 2002 at 12:37 AM

There are two door triggers

Driver Door only is (-) 18ga. GREEN/ black at drivers kick panel in black connector
Passenger doors (-) 18ga. Lt. Blue at driver's running board where harness "tees" and goes under driver seat. For coupes go to passenger's kick panel.
Dome light (-) 18ga. white at drivers kick panel in gray connecter. You can use this but it has a delay
Use diodes to isolate door triggers. Place doides inline with cathode (stripe side) away from alarm so neg. can come into alarm