2003 Honda Accord R/S Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48874
Printed Date: May 13, 2024 at 5:49 AM

Topic: 2003 Honda Accord R/S Problem

Posted By: TimeforBAss
Subject: 2003 Honda Accord R/S Problem
Date Posted: January 29, 2005 at 1:08 PM

I install a remote start in this car and everything worked fine. The car came back so that I could install the power trunk and after I installed the trunk the car starts but has a check engine light. I used a probe and found the error codes and tried to erase them. After the erase finished the codes returned. The car starts but has no throttle responce and the fan stays on. any help?

Replies:

Posted By: Teamrf
Date Posted: January 29, 2005 at 1:36 PM

Did this problem happen after you installed the trunk release? Did you use T-Taps or solder? If you used t-taps make sure all of your wires are still connected. Make sure all ignition, and acc. wires are powered during remote start.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Posted By: TimeforBAss
Date Posted: January 29, 2005 at 1:46 PM

yes this happened after I installed the trunk release and I soldered the connection. I removed the remote start from the car and the car still does the same thing. Is there a special way to erase the error codes that I am missing?

Print Page | Close Window