98 accord- pkh2 won’t start

I installed a crimestopper 800 with a pkh2 from bypass kit.com,The car will crank but not start by remote,The pkh2 module seemed to program correctly per instuction sheet.The green key symbol on dash blinks when trying ti remote start it needs to be solid.

Did you put your programming jumper into operating position after programming it.

Did you try going through the programming procedure again?

Are you getting the (-)negative output from your yellow wire during the remote start attempt? Almost sounds like the PKH2 is not being activated during the start attempt.

Are your connections to the vehicle's immobilizer wiring secure or did you use T-taps/scotch locks? The connections have to be solid or they will cause noise/data loss on the Data wire.

Is your +12 volt power source hooked to the heavy guage White wire or a small guage wire near the violet data wire? The heavy guage connection is recommended. The smaller guage wire may fluctuate when the car is starting.

I moved the jumper over to the run posistion after programing,I also tried programing again,I even used a jumper wire to ground to see if that was it,never,ever use scoth locks I always solder the wires.I also used the heavy gauge white wire for 12v.That's why it is throwing me off,the darn thing programed correctly but it will not work when remote started,I already removed the pkh2 and buried a key in the box.

What color key did you use to program the PKH2 ? Make sure you use the BLACK headed key as this is the master key to program the module.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA