’04 Ford Superduty Domelight Bypass
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48983
Printed Date: May 23, 2024 at 12:16 AM
Topic: ’04 Ford Superduty Domelight Bypass
Posted By: knucklehead
Subject: ’04 Ford Superduty Domelight Bypass
Date Posted: January 30, 2005 at 10:10 PM
Alarm-Viper 791XV
Problem-Currently using the domelight as door trigger, domelight illuminates for 25 seconds after ignition is turned-off, door opened, etc. Need to use the door triggers themselves so the vehicles not vunerable for that time period. But I am not sure which wires, where they're located, or neccessary diodes.
Replies:
Posted By: Bmnicolosi
Date Posted: January 31, 2005 at 10:32 AM
when you lock the doors, the domelight should turn off.
Posted By: knucklehead
Date Posted: January 31, 2005 at 10:35 AM
Bmnicolosi wrote:
when you lock the doors, the domelight should turn off.
I wish. With the factory keyless entry the domelight would turn-off when the doors were locked with the key FOB. With the Viper thay do not.
Posted By: KarTuneMan
Date Posted: January 31, 2005 at 11:50 AM
What wire are you using....? -------------
Posted By: knucklehead
Date Posted: January 31, 2005 at 11:54 AM
KarTuneMan wrote:
What wire are you using....?
I'm going to have to go find-out. The alarm was installed by someone else. What wire should have been used?
Posted By: knucklehead
Date Posted: January 31, 2005 at 4:09 PM
Okay, I found out that the Viper's door trigger input is connected to a BLACK/ lt.blue wire in the passenger kick panel. This wire shows 12+ volts until the dome light goes-off.
|