Print Page | Close Window

Clifford G5 siren and tilt sensor?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48999
Printed Date: May 18, 2024 at 4:58 AM


Topic: Clifford G5 siren and tilt sensor?

Posted By: bigwise1
Subject: Clifford G5 siren and tilt sensor?
Date Posted: January 31, 2005 at 1:37 AM

I have a G5 intelliguard 850 and read somewhere that the clifford g5 sirens were g5 specific. Is this true? I can't just drop a dei 513T piezo and 515R battery backup siren in? A tilt sensor was also installed but it's not very sensitive. Where and what should I look for and is adjustment easy?



Replies:

Posted By: its_radio_shop
Date Posted: February 03, 2005 at 9:03 AM

You can put one of those sirens in it if you use the secondary horn / siren output, but on the main siren speaker output, you need to use the clifford speaker. As far as the tilt sensor goes, clifford had one of the best sensors out there and its probably working normally. If your trying to test the sensor by rocking the vehicle it wont do anything, and it isnt supposed to. Arm the alarm and wait for a minute or two, then take a jack and begin jacking you car up like your going to try to remove a wheel. On my 300M the tire doesnt leave the ground before the alarm is tripped. If its not working like that, amke sure the tilt sensor is mounted correctly (as horizontal as possible)


Print Page | Close Window