Print Page | Close Window

2000 chevy malibu

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=4930
Printed Date: May 16, 2024 at 5:59 PM


Topic: 2000 chevy malibu

Posted By: mustangpony69
Subject: 2000 chevy malibu
Date Posted: October 29, 2002 at 9:35 AM

I am installing a commando auto start and the instructions say in order to bypass the coded key you must locate the 3 wire harness on the ignition. I located the 3wires and cut the yellow wire and measured the risitance between the yellow and the black wire. The security light came on and the car wouldn't start so I waited a wile and it reset. With the yellow wire cut the car starts but the security light stays on. I went through the install bay forum and it said that if I install the correct resistor The theft light will turn off and the car will start. The forum also says tha with changes in tempature the resistor value will change? Let me know if this will work or should I just install a bypass module.Thanks,Jeff.



Replies:

Posted By: PLAYER69
Date Posted: October 29, 2002 at 11:27 AM

I strongly recommend a bypass module.




Posted By: iworkatzips
Date Posted: October 29, 2002 at 12:30 PM
Use a Bypass Module. DEI part 555L.



Posted By: mustangpony69
Date Posted: October 29, 2002 at 1:14 PM
Thanks guys!!!!


Print Page | Close Window