attler 369D problem explained but...
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49516
Printed Date: May 09, 2024 at 6:45 AM
Topic: attler 369D problem explained but...
Posted By: devile
Subject: attler 369D problem explained but...
Date Posted: February 06, 2005 at 8:43 PM
Ok, remote start works fine. I diagnosed with voltage tester and found out that yes i had the right wires. HOWEVER, the relay(the once included with 369D system) is clicking, but there is not voltage coming from the relay to the door lock/unlock wires. I hope i didn't leave any details out. THanks in advance for the help
Is there a setting i need to change, or what? PLEASE HELP!!!
Replies:
Posted By: swamprat323
Date Posted: February 06, 2005 at 8:45 PM
What make and model of car do you have?
Posted By: devile
Date Posted: February 06, 2005 at 8:53 PM
1991 Jeep Cherokee 4.0L HO Limited
Posted By: auex
Date Posted: February 06, 2005 at 9:04 PM
Ok the problem is that your purple wire is connected to ground and your locks are + trigger. Connect the purple wire off of the relay module to constant +12V. Car's wire colors are pink/purple for unlock and ORANGE / purple for lock.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: devile
Date Posted: February 06, 2005 at 9:43 PM
ok now everything works, i just had the wire from the relay on ground when it should've been on a 12v source. Anyways. Now, my lock/unlock button (factory inside truck on door) doesn't do anything, it makes a noise but nothing happens. How can i fix this!!
|