Rattler 369D Fixed???
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49523
Printed Date: May 08, 2024 at 2:35 PM
Topic: Rattler 369D Fixed???
Posted By: devile
Subject: Rattler 369D Fixed???
Date Posted: February 06, 2005 at 10:46 PM
Ok, remote start works fine. I diagnosed with voltage tester and found out that yes i had the right wires. HOWEVER, the relay(the once included with 369D system) is clicking, but there is not voltage coming from the relay to the door lock/unlock wires. I hope i didn't leave any details out. THanks in advance for the help
Is there a setting i need to change, or what? PLEASE HELP!!!
Ok all i had to do was have the purple wire off the realy go to 12v instead of ground. Anyways, now the door lock switch on the drivers side (forgot to test passenger sdie) has no offect on the locks. It makes a little noise but there is no action. Any IDEAS?
1991 Jeep Cherokee Limited
Replies:
Posted By: benjammin74
Date Posted: February 06, 2005 at 11:30 PM
a little noise but no action.. sounds very familiar... haha. no seriously it is likely a problem with the lock motors themselves. The door locks in those vehicles are notorious for quitting. They wear out just like ford actuators. Check for voltage at the acutators, and if they're getting power, you'll need to put new ones in such as DEI 524N or similar.
-------------
car audio pays my bills...
Posted By: devile
Date Posted: February 07, 2005 at 7:14 AM
ah but the button on my remote locks/unlocks the doors fine!!!!!!
|