96 ford explorer factory alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49548
Printed Date: June 14, 2024 at 8:22 PM

Topic: 96 ford explorer factory alarm

Posted By: nikko
Subject: 96 ford explorer factory alarm
Date Posted: February 07, 2005 at 11:27 AM

I am installing an aftermarket alarm in a 96 ford explorer do i have to do anthing special to disable the factory alarm?

Replies:

Posted By: thepencil
Date Posted: February 07, 2005 at 11:44 AM

Depending on the aftermarket alarm you have. You should have some sort of disarm wire which will allow you to connect that to the Factory Alarm Disarm wire. It will be a negative dark GREEN/ purple wire. It is found in the driver kick panel.

You can also do a Search. The search button is on the top right.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: nikko
Date Posted: February 07, 2005 at 12:10 PM

Thanks for info thepencil

Posted By: audifive
Date Posted: February 07, 2005 at 12:57 PM

there is about four or five of those dark GREEN/ purple wires in the kick. you can trace the proper wire back to the dr rear panel where the jack goes in that compartment. thats where the keyless/alarm brain is. i did this in a 97, so it should be the same. i tapped into it under the rear seat in a wire loom. it sucks to run a wire, but then theres less room for mistakes. it needs a (-) pulse.

Print Page | Close Window