Factory Switch Vs. Remote Button
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49598
Printed Date: May 09, 2024 at 4:41 AM
Topic: Factory Switch Vs. Remote Button
Posted By: devile
Subject: Factory Switch Vs. Remote Button
Date Posted: February 07, 2005 at 10:04 PM
Ok i just recently installed my Rattler 369D Kelyess entry/remote start. Anyways since i installed it i can only lock/unlock with the remote. The factory switch in side just makes a little click noise and nothing happens. PLEASE HELP!!!
1991 Jeep Cherokee
Replies:
Posted By: profuse007
Date Posted: February 08, 2005 at 12:08 AM
how did you wire the door locks?
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: devile
Date Posted: February 08, 2005 at 7:10 AM
With the 369D in the package you should have also gotten a 451M (doorlock relay). This relay will have a harness with a thin gauge green,red and blue wires comming off it. This will plug directly into the 369D's brain. Left coming from the 451M will be:
GREEN/ Black
Blue/Black
WHITE/ Black
Brown Black
Violet
The WHITE/ black and BROWN / black wires can be taped off as they will not be needed here. THe Violet wire will need to be grounded, and the GREEN/ Black will go to your lock wire in the truck(ORANGE / purple) and Blue/black will go to unlock in the truck(Pink/purple).
The Door lock relay inside the 369D's brain are not strong enough to trigger the XJ's door locks. Once you have the kick removed, just find the boot leading into the door you should have no trouble finding the lock wires in there. To test, srtip back the wire and your DMM should got to 12v when the corresponding command is pressed from the door lock switch. You can also varify the correct wires with a fuse holder, strip back the 12v constant wire from the Remote Start, and tap the other end of the fuse holder to your lock/unlock wire. The door should lock or unloce depending on the wire you send 12v too.
|