Door Locks on 97 Mitsu Diamante

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49799
Printed Date: May 21, 2024 at 3:26 PM

Topic: Door Locks on 97 Mitsu Diamante

Posted By: zanthius
Subject: Door Locks on 97 Mitsu Diamante
Date Posted: February 10, 2005 at 12:54 PM

Hey guys and gals.

I'm in the process of installing a BullDog RSA112 system. The remote start works well. However, I am having problems with the door locks. I could not find any wires listed in the Wiring Chart. So I probed around and found 2 wires behind the switch. They both go to the actuator, then they change color afterwards. Anyways, I got the Lock to work, but the Unlock only unlocks the Driver door; not the rest. I think the wires are ONLY to the driver door actuator. Where are the other wires to the rest of the car???

Also, I found a pair of wires that are GND and goes +12V when lock and unlock are applied. But applying +12V to these does nothing.

I am so lost... If anyone installed on this car, plz lemme know what wires i need for unlock!:(

Thanx..

Replies:

Posted By: thepencil
Date Posted: February 10, 2005 at 2:00 PM

You need to program the unit to a double pulse.

MITSUBISHI, DIAMANTE, 1997, Power Unlock

A single pulse unlocks just the drivers door, and a double pulse will unlock all of the doors.

Power Lock blue - in drivers door
Power Unlock RED / green - in drivers door

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: zanthius
Date Posted: February 10, 2005 at 3:09 PM

Thanks, I appreciate it.

Yep....those were the wires i used......theres no programming instructions for double pulse...just longer duration.....I contacted bulldog. they havent responded. anyone know if theres any wire that doesnt require double pulse?

Posted By: madBedex
Date Posted: February 10, 2005 at 4:51 PM

Hi!

Go to any car'stereo store and buy a double pulse unlock module,

it will do the job no doubt. No programming is required. So,just

hook on,that's it.

-------------
madbedex

Posted By: zanthius
Date Posted: February 11, 2005 at 12:51 PM

thanks....i finally got a hold of bulldog. that model does not do double pulse...so i'll just wire some relays and cap to do it...thanks again...