1995 Toyota Camry Power Door Lock
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50138
Printed Date: July 05, 2025 at 3:01 AM
Topic: 1995 Toyota Camry Power Door Lock
Posted By: td0205
Subject: 1995 Toyota Camry Power Door Lock
Date Posted: February 15, 2005 at 3:52 AM
My car is 4 door 1995 Camry. Power door lock in my driver door does not work when I press on the switch on door trim.
As I recall, there are 2 bundles of wires going to power door lock actuator. One bundle has 4 wires and the other bundle has 3 wires. Which wire should I check the voltage at for unlock and lock? What voltages activate the Lock and unlock? Do you have wiring chart or know where I can get more information on this?
Also, there are linkage rods from actuator to outside door handle and to inside manual switch. Do I have to remove outside door handle first before I can remove actuator? In addition, the openning is so small that there is not enough room to remove the actuator. Do I have to remove the glass window assembly as well before I can remove the door lock actuator?
Thank you all for any replies.
Replies:
Posted By: auex
Date Posted: February 16, 2005 at 8:49 PM
Ok just to be sure, only the driver's door doesn't work with the switch? If that is the case then I would just add an aftermarket actuator and cut the wires going to the factory one and wire it to the aftermarket. Don't bother to remove the factory actuator.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
|