Clifford RSX 3.5 Door lock Question
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50333
Printed Date: May 18, 2024 at 9:34 PM
Topic: Clifford RSX 3.5 Door lock Question
Posted By: Era1
Subject: Clifford RSX 3.5 Door lock Question
Date Posted: February 17, 2005 at 5:55 PM
Can I just used the door lock wire and tap into the lock switch in my highlander without adding a relay. Search the forums and somebody said yes and other said no. Can any of the expert here can give me a straight answer for that. Thanks!!
Replies:
Posted By: f00dstamps
Date Posted: February 17, 2005 at 6:40 PM
i'm not an expert but i know the highlander needs relays for the door locks.
https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1070.pdf
i installed the same alarm in an 05 sequoia.
Posted By: metaverse
Date Posted: February 17, 2005 at 6:57 PM
Clifford RSX 3.5 should have the DEI 451M relay pack for locks. You can connect it directly, yes.
Posted By: Era1
Date Posted: February 17, 2005 at 11:04 PM
I got both answer again, Can anybody help me here?
Posted By: metaverse
Date Posted: February 19, 2005 at 2:02 AM
f00dstamps said you needed a relay. I said the rsx 3.5 comes with the 451M relay pack. Use that relay pack to connect to the door lock/unlock wires. What else do you need help with ?
Posted By: chris354
Date Posted: February 19, 2005 at 11:30 AM
Yes you have to use one for sure also need diodes. On some toyotas with this lock system you have to use relays to have a higher amprage ground than what the brain can put out. look at this link for wiring diagram. https://directechs.com/techtips/pdfs/resources/security/directed_techtips/1070.pdf
Posted By: bretbowman
Date Posted: February 26, 2005 at 6:47 AM
my 2002 Sequoia is the same. You MUST use relay (unless the alarm has onboard for locks - just as easy to wire one in if you have it). You MUST interrupt the "lock detection" wire while locking. If you study the 1070 document and wire it EXACTLY as shown you should be fine. If you want to wire for "progressive" or "2 stage" locking, then there's a different recipe (if so, email me: bretbowman@yahoo.com)
-------------
2002 Toyota Sequoia Limited 2WD (Clifford G5 Avantguard 5 w/ 2 SmartWindows modules) - IT Engineer - NRA Life Member - LDS Return Missionary - Married for time AND ETERNITY - Eternally sealed family
|