95 jeep grand cherokee keyless remote ala

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50346
Printed Date: July 05, 2025 at 5:42 AM

Topic: 95 jeep grand cherokee keyless remote ala

Posted By: nazeer
Subject: 95 jeep grand cherokee keyless remote ala
Date Posted: February 17, 2005 at 9:20 PM

i bought a used 95 jgc, w/out the keyless entry remote, just bought one on ebay, used the instructions below, that i got off the forum, but nothing happened. meaning the locks never cycled on/off. the remote is new as well, it flashes twices when i hold it down, but that's all.

the problem i had before was, if i locked the door electronically from the passenger door, the next time i would open the car door from the driver side, the alarm would go off. the only way to prevent this was to unlock the passenger door first. also, anytime i would open the driver side door, and unlock all the doors using the unlock switch on the door handle, it would cause the alarm to go off if anyone tried to open any other door, prior to me turning the car on. i would be forced to open my door first, start the car, then unlock the doors. any help with this would be much appreciated

thanks

the instructions

1. Put key in ign. Leave in off.
2. Open driver door, leave open throughout.
3. Manually push door lock button to "lock" position, not using electric
door locks, just manually push lock button.
4. Turn ign to "run" position.
5. Within 20 seconds, hold lock button on remote till remote LED flashes
twice and electric door locks cycle on /off.
6. Within 20 seconds, push manual door lock back to "lock" position and
press "lock" button on 2nd remote till it flashes twice and locks cycle
again.
7. Turn ign key to "off" position within 20 seconds.

Replies:

Posted By: boomer_106
Date Posted: February 24, 2005 at 9:39 PM

Here are the wiring colors for that vehicle. You will have to also interface the OEM alarm disarm wire to keep it from going off on you. The locations of the wires are on the sheet at the right.

Jeep

Grand Cherokee

1993-1995

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	RED / WHITE FUSED AT #	AMP AND PINK/BLACK FUSED AT # AMP
OEM Alarm Disarm:	VIOLET / YELLOW	(-) DRIVER KICK PANEL
Dome Lights/Superv:	YELLOW (-)	DRIVER KICK PANEL OR COURTESY LIGHT
OEM Horn:	GRAY/ORANGE (-)	STEERING COLUMN HARNESS OR AT RELAY
Power Lock:	ORANGE / VIOLET	DRIVER'S KICK PANEL **
Power Unlock:	PINK/VIOLET	DRIVER'S KICK PANEL **
Trunk Release:	ORANGE / BROWN (+)	LIFT GLASS RELEASE (AT SWITCH)
Alarm Input Wire:	YELLOW (-)	DRIVER KICK PANEL OR COURTESY LIGHT
Notes:	** See Note #202 - Positive Pulse Door Lock Diagram.

Posted By: nazeer
Date Posted: April 03, 2005 at 1:31 PM

yeah, that is of no help to me

Posted By: boomer_106
Date Posted: April 03, 2005 at 8:30 PM

Does your keyless entry system provide a wire for disarming the alarm? If not you're going to have to find a way to send a ground signal the the OEM alarm disarm wire.

OEM Alarm Disarm:

VIOLET / YELLOW

(-) DRIVER KICK PANEL