illuminated entry problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50378
Printed Date: May 17, 2024 at 2:30 PM

Topic: illuminated entry problems

Posted By: davidachew
Subject: illuminated entry problems
Date Posted: February 18, 2005 at 11:23 AM

ok here is the situation, installed remote entry alarm in 05 f250, works great except the illuminated entry. this is what i did, spliced the positive door triger and illuminated entry output togeather and ran a siingle wire to the courtesy lite connection wire. is that where my problem is? do i need to run 2 seprate wires to that connection? Im lost. Thanks for the help.

Replies:

Posted By: draasch
Date Posted: February 23, 2005 at 9:43 AM

what unit are you using????

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: swamprat323
Date Posted: February 23, 2005 at 12:25 PM

do you have an onbord realy for dome light.

Posted By: dar1
Date Posted: February 23, 2005 at 9:10 PM

Depending on schematics for your vehicle you may need a relay and direct positive feed from +12volt source

-------------
one love

Posted By: cutter1122
Date Posted: February 23, 2005 at 9:24 PM

Door Trigger

BLACK/ yel (L), BLACK/ pink (R)

DKP, gray plug, pins 22, 23

The wiring above is for vehicles without keyless entry. Vehicles with keyless entry, the door trigger wires are found at the BCM, green plug. The LF door trigger is BLACK / YELLOW in pin 4. The RF door trigger is BLACK/ pink in pin 5. The LR door trigger is BLACK/ lt. blue in pin 12. The RR door trigger is BLACK/ white in pin 13. Use all wires and diode isolate each.

Print Page | Close Window