First Time Installation

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50589
Printed Date: May 09, 2025 at 11:23 AM

Topic: First Time Installation

Posted By: Taito
Subject: First Time Installation
Date Posted: February 21, 2005 at 10:15 PM

I just got a Compustar 2W900FM-AS and I am going to install it myself, and probably with a friend on a 97 Honda Accord with a factory security system. I have the wire diagram, so the question is for wiring I would match the car diagram with the brain diagram and mount the brain and some other things and that is it?? Anybody have any tips or instructions for a newbie?

Thanks

Replies:

Posted By: boomer_106
Date Posted: February 21, 2005 at 10:41 PM

Take your time. Doublecheck your connections. Test the wires with your meter before you interface them. Soldering the wires is recommended. Have fun and learn alot.

Posted By: johnnyb1231
Date Posted: February 22, 2005 at 1:02 AM

every piece of info you need for wiring your car posted_image

12volts	white	+	ignition harness
Starter	BLACK/ white	+	ignition harness
Second Starter
Ignition	BLACK / YELLOW	+	ignition harness
Second Ignition
Third Ignition
Accessory	yellow	+	ignition harness
Second Accessory
Keysense
Power Lock	BLACK/ white	-	gray conn. above fuse
Notes: SE models, use factory alarm arm wire for lock and factory alarm disarm wire for unlock.
Power Unlock	orange	-	box in blue tape
Notes: SE models, use factory alarm arm wire for lock and factory alarm disarm wire for unlock.
Lock Motor	WHITE/ red		drivers door harness
Unlock Motor	yellow		drivers door harness
Parking Lights+	RED / black		blue plug fuse box
Notes: Also a male blade terminal is available in the fusebox DKP.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	blk/wht	-	gray plug right of column
Dome Supervision	use door trigger
Trunk/Hatch Pin	orange	-	gray plug right of column
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm	RED / yellow	-	passenger kick or alarm
Notes: Factory alarm is located under the passenger front seat.
Factory Alarm Disarm	RED / blue	-	passenger kick or alarm
Notes: Factory alarm is located under the passenger front seat.
Disarm No Unlock
Tachometer	blue	AC	at distributor
Wait to start
Brake Wire	GREEN / WHITE	+	brake switch
Parking Brake
Horn Trigger	blu/red or grn/blu	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: No	Type: N/A	Part #: N/A
Notes: N/A

Posted By: alik
Date Posted: February 22, 2005 at 11:17 AM

WHERE DID YOU GET YOUR Compustar. i'M CURRENTLY LOOKING FOR A GOOD DEAL ON IT ?

Posted By: Taito
Date Posted: February 22, 2005 at 3:38 PM

alik I got mine on ebay. You just have to keep a look out on ebay.

Ok so with the chart aboce I go to my alarm brain wireing diagram and match up each of the wires? So the chart says '12volt' is white and the alarm diagram '12volt' is red so I just crip the two wires together? Is that it or am I missing something else. Thanks for the help as you can tell this is my first time installing an alarm, I have done cd recievers, but thats different.

Posted By: profuse007
Date Posted: February 22, 2005 at 6:41 PM

AT or MT accord?

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: Taito
Date Posted: February 22, 2005 at 8:47 PM

AT accord EX four door with factory security system, which I am probally going to take out.

Posted By: johnnyb1231
Date Posted: February 22, 2005 at 9:11 PM

you might have a problem with the domelight coming on if you take out the factory alarm... we had an experience where after us unplugging the FA the domelight wouldnt come on with the doors open... so its just a matter of finding those 2 wires and connecting them