2000 S10, prostart 3300 remote starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50640
Printed Date: May 03, 2025 at 4:59 AM

Topic: 2000 S10, prostart 3300 remote starter

Posted By: DENNY10700
Subject: 2000 S10, prostart 3300 remote starter
Date Posted: February 22, 2005 at 6:22 PM

I installed a prostart 3300 in a S10 (2000) The door locks are not working, the remote starter only gives a (-) output for the lock and unlock, it seems the trucks wires that are indicated are a positive output, any suggestions or does anyone have the schematics for the door lock control for a 2000 S10??

Thanx for your help

Replies:

Posted By: boomer_106
Date Posted: February 22, 2005 at 6:32 PM

Here is the info for that trucks locks Denny. You are correct about the positive pulse. You will just have to use two relays and connect them like shown on the relay page at this site for positive doorlocks. https://www.the12volt.com/doorlocks/page3.asp#3wp

Chevrolet

S-10 Pickup

1996-2003

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	RED (2)	IGNITION SWITCH HARNESS
OEM Alarm Disarm:	N/A	IN SCHEMATICS
Dome Lights/Superv:	BLACK (-)	AT PIN SWITCH OR COURTESY LIGHT
OEM Horn:	BLACK (-)	STEERING COLUMN HARNESS
Power Lock:	L BLUE	INSIDE OF LOOM IN DRIVERS DOOR OR
Power Unlock:	WHITE	AT KEYLESS ENTRY MOD. UNDER DASH ***
Trunk Release:	N/A
Alarm Input Wire:	BLACK (-)	AT PIN SWITCH OR COURTESY LIGHT
Notes:	*** See Note #202 - Positive Pulse Door Lock Diagram.

Posted By: DENNY10700
Date Posted: March 02, 2005 at 3:43 AM

Thanx for the help guys!!

Denny

Posted By: boomer_106
Date Posted: March 02, 2005 at 6:35 AM

You're Welcome. Does that mean you got it done?

Posted By: DENNY10700
Date Posted: March 02, 2005 at 10:49 AM

She's all done, I mainly work on Toyota/Lexus products so the S10 was a learning experience!!

Dennis

Posted By: DENNY10700
Date Posted: March 17, 2005 at 4:28 AM

I have this s10 that I put a remote starter in (prostart) with passlock security. I installed the module for the passlock system It works fine but the security light comes on while driving. I can shut it off restart and it is fine for about 3 min then it comes on again. It seems to be getting more frequent. Any ideas guys??

Thanks Denny

Posted By: thepencil
Date Posted: March 17, 2005 at 10:18 AM

GM Passlock security problem, my favourite. Try changing the passlock II bypass module. If that still doesn't work consider running a single relay for the bypass.

Here's a diagram on how it can be done.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: DENNY10700
Date Posted: March 21, 2005 at 11:13 AM

Hi All Again

I have a prostart mt3300 in a s10 pick-up. It has passlock2 security. I bought the bypass and it works. But now and then when you drive the car the security light comes on. When the car is shut off it will start again but the light comes on while driving at different times. Any ideas??

Pretty frustrated.

Denny

Posted By: mnviking28
Date Posted: March 21, 2005 at 12:39 PM

When you re-start it, are you using the key or the prostart?

-------------
MNViking28

Posted By: DENNY10700
Date Posted: March 21, 2005 at 3:55 PM

I can use both and it will start, Mainly the remote start is used. Would the factory keyless entry have anything to do with this problem?? The car will start either way but when she runs the bloody security light comes on. But all is normal when the car is shut off ready to start with key in or remote.

Thanx in advance for all the help.

Denny