2004 nissan pathfinder, avital 4400

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50716
Printed Date: May 17, 2024 at 3:22 AM

Topic: 2004 nissan pathfinder, avital 4400

Posted By: ksingh
Subject: 2004 nissan pathfinder, avital 4400
Date Posted: February 23, 2005 at 8:40 PM

hey whats up guys just installed an avital 4400 in a pathfinder now when i remote start the vehicle it works fine, i had forgot to program the tach so when i did program the tach and i tried to remote start the vehicle it didnt start the dash lights would light up and the parkin lights flash

now what i did after that was i used voltage sense and then it worked fine now after 4 days it doesnt work

can anyone out there please help me out thanks

-------------
Kenny

Replies:

Posted By: cutter1122
Date Posted: February 23, 2005 at 8:54 PM

tach: WHITE/ green at ECM, right side of steering column, rear firewall

for the transponder bypass check for PKN2 www.bypasskit.com

Posted By: ksingh
Date Posted: February 25, 2005 at 1:20 PM

that really dont ans my question nor help me solve my problem

-------------
Kenny

Posted By: Velocity Motors
Date Posted: February 25, 2005 at 1:32 PM

Have you tried reattaching the tach wire on the tach wire off the truck and releasrning it again ? Try this and post your results.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: ksingh
Date Posted: February 26, 2005 at 8:29 AM

yeah i did try it and it started but the tach needed to be reprogram so when i did pprogram the tach and i tried starting it again it didnt even start all it did was the ignition came on and the parking lights flash but no sign of cranking or anything like that

-------------
Kenny

Posted By: Velocity Motors
Date Posted: February 26, 2005 at 9:58 AM

Check the output on the starter wire to the motor side of the relay ( if starter kill relay was installed ) for power when cranking. Sounds odd to me that the system doesn't work now ??

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Print Page | Close Window