1993 Mazda MPV with Clifford alarm.

hello guys, my friend ids748 posted couple of weeks that he needs the instructions on how to add a new remote to the clifford system installed in a 1993 mpv, but he didn't know the model number, so no body could really help him. I got the model number now, its intelliguard 800iq. Anybody help plz. thx

Look in the user-selectable features on pages 20-24 for instructions on how to add remotes.
https://directechs.com/guides/manuals/og/clifford/intelliguard800iq_owners.pdf

okay, I had this, i don't understand what its saying. Can anybody put it in normal english plz. thx

Well, I took this from the manual and tried to make it easier for you. If this doesn't help then I suggest calling the Customer Service Department at 800-824-3208 and they can walk you through it.

Turn on the ignition, or start the engine.

-Enter your valet code (Your factory-set valet code is the single digit “2” or whatever you changed it to), then press the PlainView switch to its momentary side for about 3 seconds until you hear a siren chirp (the system LED will also turn on to indicate program mode.)

You are now in the “Feature Select” position.

-Select the feature column: Toggle the switch in and out of the latched position the same number of times as the column number of the selected feature {in your case twice) (NOTE: each latched-to-center motion is counted as one). Pause. You will hear the same number of chirps as the column number you have selected, audibly confirming your selection.

-Select the feature ROW: Press and release the momentary side the same number of times as the feature’s row number. (in your case once) You will hear a chirp each time you press it.

-If there is a NOTE for the selected feature, perform the actions noted. (NOTE 1: Transmit channel 1 (press button 1) on the new remote control. You will hear one chirp to confirm programming of channel 1.)

You may now select another feature, to select another feature in that column (which is what you want), repeat the step (Select the feature ROW) within the next 10 seconds. (you need to get to row 2) then program remote button 2. Then continue on to row 3 and do button 3, then row 4 to program remote button 4 and finally row 5 the same way. (I believe the additional remotes allow up to 5 buttons to be programmed. I don't know if you can control all 12 functions with the additional remotes. It may be limited)

If you haven't selected a new ROW after 10 seconds you'll hear 3 chirps which means you are now back in the “Feature Select” position..

To exit program mode, turn the ignition off (you’ll hear 3 chirps and the LED will turn off to indicate exit of program mode). Or just wait 60 seconds and the
system will automatically exit program mode.

Not sure if you have this but it's the install manual. It also has remote programming instructions.
https://www.clifford.com/guides/wiring/intelliguard800iq_wiring.pdf

Program channels 1–5 of each remote that will be
used with the IntelliGuard 800-IQ.

thx a lot for your help.

Let us know if you get it figured out.