2001 Silverado DEI Passlock help
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=51008
Printed Date: September 06, 2025 at 2:42 AM
Topic: 2001 Silverado DEI Passlock help
Posted By: Accord_boy619
Subject: 2001 Silverado DEI Passlock help
Date Posted: February 27, 2005 at 9:17 PM
Im installin a DEI remote start with the 555L paslock module. My problem is that when the truck is started by remote, it starts and dies. any ideas? I hooked up the Yellow to passlock wire ign. side(yellow), Black w / YELLOW to passlock BCM side (yellow), Black to orange w/ black. any suggestions pls.
Replies:
Posted By: audioCHIEF
Date Posted: February 27, 2005 at 9:33 PM
If that is not working U can measure the resistance across the yellow wire & add a relay and the right resistance. ------------- Chief did it !
Posted By: SEXIFIED
Date Posted: February 27, 2005 at 9:41 PM
make sure you have the correct yellow wire, there are 2 of them in that harness....3 if you include the starter wire, chances are you either have the wrong wire, haven't powered up the 2nd ignition or the ground while running is not working on the output of the remote starter.
-------------
SWEET.
Posted By: Accord_boy619
Date Posted: February 27, 2005 at 10:35 PM
I have the right yellow wire cuz when I cut it the truck wouldn't run w/key. But if its hooked up it runsw/key. I have the second ing powered up.
Posted By: chris354
Date Posted: February 27, 2005 at 10:58 PM
I would try grounding the 555l black wire to the kick panel instead of the ORANGE / black, sometimes the ref. ground is not strong enough for the 555l .
Posted By: chris354
Date Posted: February 27, 2005 at 11:04 PM
Also are are you using tach or voltage. If the security light is not on when it dies its probally your tach signal.
Posted By: secureauto
Date Posted: February 27, 2005 at 11:07 PM
Just wondering, did you program the 555L, start the car with the key for at least 5 seconds?
-------------
ASE Certified
Posted By: Accord_boy619
Date Posted: February 27, 2005 at 11:31 PM
secureauto wrote:
Just wondering, did you program the 555L, start the car with the key for at least 5 seconds?
Yes I programed it
Posted By: secureauto
Date Posted: February 27, 2005 at 11:37 PM
audioCHIEF wrote:
If that is not working U can measure the resistance across the yellow wire & add a relay and the right resistance.
You can try replacing the 555L or do what audioChief wrote, I've added a link for a diagram:
Passlock bypass using relays------------- ASE Certified
Posted By: iskidoo
Date Posted: February 28, 2005 at 12:09 AM
You hooked your Red to constant +12v Red in the main harness, Pink to the Pink Ignition in the main harness, and Blue/Black to the status (-) ground out when running from the remote starter correct?
Posted By: Accord_boy619
Date Posted: February 28, 2005 at 8:03 PM
Never minds I found it, I needed to learn the puter. Thanx for the replies
|