Print Page | Close Window

alarm quit responding

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=5130
Printed Date: August 20, 2025 at 7:32 AM


Topic: alarm quit responding

Posted By: park311
Subject: alarm quit responding
Date Posted: November 04, 2002 at 6:21 PM

I have a 99 nissan sentra installing a cs-2011rs series II (crimestopper) anyways I had my remote start working, lights flashing and the siren would chirp and something happened to make it all quit.

I was wondering if anyone could pinpoint my problem...my doors are negative I don't need relays for my locks right..I have green from the 5 pin hooked up to the RED / white door trigger, the green from the 3 pin hooked up to the gray wire for power lock and the blue from the 3 pin hooked to the PURPLE / silver dots for power unlock (I have factory keyless entry)

anyways my alarm is not responding to the transmitters at all....and I can't get my valet switch to flash my parking lights when I use it.  The instructions call for me to push the valet button 5 times to program and then I should get a flashing response( instead my led light comes on solid and flickers whenever I push the switch again)...could be something to do with my tach wire? I have it hooked up the blue/orange wire coming off the ecm or could it maybe be the hood switch I installed the hood switch that crimestopper provided. I don't believe it is my tranmitters because they still show juice...I don't know if it matters or not, but my siren goes off when I disconnect my ground wire. Does anyone have any ideas?




Replies:

Posted By: Velocity Motors
Date Posted: November 05, 2002 at 12:51 AM

Does the transmitter make any beeps or respond to you pressing the buttons ? Check the battery and the terminals that touch both ends of the battery to ensure they are infact touhing the battery coontacts.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: park311
Date Posted: November 05, 2002 at 2:56 PM

Yeah both the transmitters light up showing juice whenever I press a button, I checked the battery contacts to make sure they were touching anyways, they are.....

I don't know if this helps but today I unplugged all the wires and replugged them and whenever I turn the key to the on position the doors lock and when I turn it off the doors unlock.....and when I press the valet switch 5 times the led light comes on solid....but to still no flashing lights..I mean before when everything was working the lights flashed after everything quit I checked the connection on the parking lights and soldered the wire..this is confusing

thanks for responding/ I finally got crimestopper to respond to my emails, but all they gave was a number and extension (tried that before)...I'll try again later cause I believe my waterpump needs to be replaced..which is a way more important than my alarm






Print Page | Close Window