Multiple Window Modules.
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=51328
Printed Date: May 03, 2024 at 2:34 AM
Topic: Multiple Window Modules.
Posted By: thsonnen
Subject: Multiple Window Modules.
Date Posted: March 05, 2005 at 4:18 AM
Getting ready to install an Autopage 855lcd into a custom Caprice. Ordered 2 DEI530t's to allow the owner to roll all 4 windows up and down. I have 2 AU-93's laying around, and would like to use them on his ragtop
motorized sunroof. I'll use one to open, and the other to close upon arming. The manual for the AU-93 recommends
the installer to use the alarm's 500ma ground when armed,
and not to connect it to anything else. The pink wire is to be used for another device that requires a 500ma ground when armed from the AU-93. My question is, can I use the pink wire and diode isolate each sensor, the starter kill relay, the 2 530t's, and the 508 invisibeam
sensor from this pink wire, or should I just use the
Autopage's ground when armed output for all the sensors?
Replies:
Posted By: jimmeezgolfvr6
Date Posted: March 05, 2005 at 4:35 AM
you should use the autopage's ground out when armed and lead it to a relay that wire come out with true ground upon armed so that it's not just 500mA. then, diode isolate to each of the items that you need connect an armed out signal. good luck!
-------------
all problems can be resolved with a hammer
|