Print Page | Close Window

Remote Start on crappy alarm (Nitro)

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=51742
Printed Date: May 12, 2025 at 5:24 PM


Topic: Remote Start on crappy alarm (Nitro)

Posted By: steveholtam
Subject: Remote Start on crappy alarm (Nitro)
Date Posted: March 11, 2005 at 10:43 AM

The person who translated the instructions for this Nitro alarm I am installing must have been drunk, and I am wondering if anyone here can make sense of these wires. Here are the wire outs I dont quite understand-

Harness #1
Green Wire - "Air Condition Wire" & "Keyhole on wire", two wires.
Grey Wire - "Connect start engine wire"

Harness #2
Green Wire - "Alternator" (When successfully starting, positive power is output)

As you can see this alarm is lacking inputs. Anyone have a guess on how I would hook up these wires? I have attached a scan of the install instructions which show some of the wires going to the starter or ignition.

I'm still waiting on my PLDATA passkey bypass, but thought I could get these wires hooked up in advance. Also, no starter disable relay yet.

posted_image



Replies:

Posted By: joe_1
Date Posted: March 11, 2005 at 11:48 AM

The green wire has 2 outputs one that you can use to operate air con - the other you have to connect to the ignition wire that powers up the cars ignition system relays etc and the grey wire goes to the starter motor wire

on the second harness the green wire has to have a 12v + signal when started it says to use alternator wire also you can use the fuel pump wire if the car this system is being fitted to has an electric fuel pump, this wire is used to disable output when the car is started from the alarms relay for remote start.

also when connecting the relay to disable the starter make sure you connect the alarms grey wire to the output of the relay to the starter and not from keyside because if you remote start the car when the alarm is on the car will not start hope this helps let me know if you have any problems.


Print Page | Close Window