viper 300

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52040
Printed Date: May 14, 2024 at 11:55 PM

Topic: viper 300

Posted By: swamprat323
Subject: viper 300
Date Posted: March 17, 2005 at 6:43 AM

I pulled this alarm out a a car fro some one to put in another car. It says viper 300 on it no 300HF or ESP, just 300. Does any one have a manural for this. i look it up on direct site, but the 300 ones coem up as a 300HF. This alarm has no plug in for a LED or valet switch. it only has the main and door lock plug. it had the led and toggle switch in there when i pulled it out, i had extra ones of these so left in in. any body have info on this unit.

Replies:

Posted By: drp6730003
Date Posted: March 17, 2005 at 8:44 AM

I used to have that one, 1993 version of viper. If your brain was distributed from 2nd-quarter, it features nuisance prevention circuitry, two-stage progressive door trigger, remote valet and revised operation of channel 2. And for more from 3rd-quarter of 1993, you got two-way +/- door lock outputs and onboard defeatable current sense.

Summary of harnesses is following,

H1/12 ORANGE (-)ground when armed output
H1/11 WHITE (+)parking light output
H1/10 BLUE/WHITE 2v(-)status LED output
H1/9 GRAY (-)valet/switch input
H1/8 GREEN (-)door switch input
H1/7 BLUE (-)instant sensor input
H1/6 PURPLE (+)door switch input
H1/5 BLACK (-)chassis ground input
H1/4 YELLOW (+)switched ignition input
H1/3 BROWN (+)siren output
H1/2 RED (+)12v constant input
H1/1 RED / WHITE (-)auxiliary channel 2 (-)output, 200mA capable

<Secondary Harness H2, 3-pin white flat connector>The optional 451T power door lock relay module plugs directly into this connector.

H2/A GREEN (-)lock output, 200mA-capable
H2/B RED (+)12v constant 200mA-capable. Relay term. #86 only!
H2/C BLUE (-)unlock output, 200mA-capable

BLACK WIRE FROM MODULE = RECEIVER ANTENNA (DO NOT GROUND)

Posted By: swamprat323
Date Posted: March 25, 2005 at 7:53 AM

Does any one have a manurl for this, like to see the program features it have. The one on direct website comes up as the 300 HF.

Posted By: drp6730003
Date Posted: March 25, 2005 at 9:23 AM

To change the setting, slide open the lid of the brain to access to programming loops.

RED LOOP : passive arming on (cut for active arming)
BLUE LOOP : chiro on (cut for defect)
GREEN LOOP : pasive lock on (cut for active lock)
WHITE LOOP : current sense off (cut to enable current sense)

Posted By: Fongo
Date Posted: April 02, 2005 at 9:09 AM

I have a manual for the Viper 300. In fact I have both the owners manual and the installation manual. Email me at kdforgo@yahoo.com